Martin Pantograph Bruksanvisning
Martin
Inte kategoriserad
Pantograph
Läs gratis den bruksanvisning för Martin Pantograph (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 30 personer och har ett genomsnittsbetyg på 3.5 stjärnor baserat på 15.5 recensioner. Har du en fråga om Martin Pantograph eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Martin Pantograph
Installation Instructions
The Martin Pantograph is specifically designed for hanging Martin luminaires from
ceilings or other load-bearing structural elements. It may be used to suspend a
fixture weighing up to 22 kg (48 lbs), and provides a drop from the ceiling to the
attachment point of 12 to 62 cm (4.75 - 24.4 in.).
Warning: Never place your hands between the folding side plates when
the pantograph is unlocked!
IN S T A L L A T I O N R E Q U I R E M E N T S
F O R T H E F I X T U R E
The Pantograph attaches to the fixture mounting bracket, if applicable, or to the
Omega clamp attachment bracket that is included with Martin moving-head
fixtures. The Pantograph cross-plate to which the fixture fastens may be reversed if
necessary.
The fastening hardware shall be metric grade 8.8 or better. Use M12 hardware to
fasten the Pantograph to the Omega bracket and to most mounting brackets. (Small
fixtures may require M10 hardware.) A typical installation requires an M12 x 45
mm hex cap screw, M12 washer, and M12 lock nut. An additional hex nut may be
placed between the Pantograph and the Omega bracket to provide clearance for the
quarter-turn locks.
F O R T H E P A N T O G R A P H
The Pantograph fastens to the ceiling or other load-bearing structure with four sets
of 8 mm (5/16 in.) hardware. The fasteners are inserted through 42.5 mm washers
(included) and then through the 24 mm holes in the base to allow room for precise
alignment. Additional fasteners may be inserted through the 8.5 mm holes in the
Pantograph base.
The specific fastener type and length varies according to substrate. It is the
installers responsibility to determine a suitable fastening method.
P/N 35000539, Rev. A © 2001 Martin Professional A/S, Denmark
Produktspecifikationer
| Varumärke: | Martin |
| Kategori: | Inte kategoriserad |
| Modell: | Pantograph |
Behöver du hjälp?
Om du behöver hjälp med Martin Pantograph ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Martin Manualer
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
26 September 2024
24 September 2024
24 September 2024
23 September 2024
Inte kategoriserad Manualer
- Integra
- Dorma
- Kenko
- Positive Grid
- Yuer
- Enbrighten
- IMAC
- Vortex
- Western Digital
- Debel
- Jedo
- Inventum
- Roccat
- Elvid
- Inter-Tech
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025