Meaco Heat Motion Eye 1.8kW Bruksanvisning
Läs gratis den bruksanvisning för Meaco Heat Motion Eye 1.8kW (7 sidor) i kategorin element. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 1.5 recensioner. Har du en fråga om Meaco Heat Motion Eye 1.8kW eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/7
MeacoHeat PTC Ceramic Heaters
MeacoHeat Motion Eye 1.8kW
MeacoHeat MotionMove Eye 2.0kW
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.
INSTRUCTION MANUAL [EN]
MeacoHeat
2 [EN]
SAFETY INFORMATION PLEASE READ BEFORE USE –
WARNING: In order to avoid overheating, do not cover the appliance with anything, especially ammable materials,
such as clothes or paper.
CAUTION: In order to avoid hazards due to inadvertent resetting of the thermal cutout, this appliance must not be
operated through an external switching device, such as timers, programmers, separate remote-control system or
connected to a circuit that is regularly switched on and o by the utility.
CAUTION: Some parts of this product can become very hot and cause scalding. Particular attention has to be given
where children and vulnerable people are present.
In case of a failure whilst under warranty we will collect the heater from you for repair/replacement, therefore please
save the packaging and keep it safe away from children. When you do dispose of the packaging please recycle.
When turned on do not touch the air outlet as it will be hot in operation.
WARNING - This appliance is intended for use in a domestic environment only. Any other use is not recommended by the
manufacturer and may cause re, electrical shocks or other injury to person or property. When using electrical appliances,
basic safety precautions should always be followed:
1. Keep Children Away: Do not allow children to play with or around this unit, which could result in injury. Be sure the
unit is inaccessible to children when not attended.
2. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards involved.
3. Ensure that the air inlets and outlets are not blocked or covered.
Do not place the unit too close to curtains or other objects - min 10cm.
4. Keep Unit Grounded: Always operate the unit with a grounding plug and a grounded electrical outlet. A grounding
plug is an essential safety feature that helps reduce the risk of shock or re.
5. Protect Power Cord from Damage: Never operate a unit with a damaged power cord, as this may lead to electrical
or re hazards. If the power supply cord is damaged, it must be replaced by manufacturer, its service agent or
similarly qualied persons in order to avoid a hazard.
6. Protect against electrical shocks, do not immerse unit, plug or cord in water, or spray with liquids.
Do not run power cord under carpeting, or cover with rugs or runners. Arrange the cord away from areas where it
may be tripped over.
7. Extension Cords: Extension cords must be grounded and able to deliver the appropriate voltage to the unit.
8. Where possible, avoid the use of an extension cable as they may overheat and cause a risk of re. Only use an
extension cord after ensuring it is in perfect condition. Extension leads can also cause voltage drop which will aect
the heater This is more likely when being used in garages and out buildings. .
9. Handle with Care: Do not drop, throw or crash the heater. Rough treatment can damage the components or wiring
and create a hazardous condition.
10. Run on Stable Surface: Always operate the unit on a stable, level surface, for example the oor or a strong counter,
so that the heater cannot fall and cause injury. Use on a deep pile carpet should be avoided as this could prevent
the tip over switch from activati ng.
11. Keep Out of Water: Never operate the unit in pooled or standing water, as this may create a risk of injury from
electrical shock. Do not store or operate outdoors. If electrical wiring or components become wet, thoroughly dry
them before using the unit. If in doubt do not use the heater and consult a qualied electrician or a Meaco approved
engineer.
12. Keep Air Intakes/outlets Clear: Do not clog or block the air intakes/outlets by placing the heater too close to curtains,
walls or anything that will restrict the air inlet. This may cause the unit to overheat and result in a re or electrical
hazard.
13. Keep Filter Clean: Always use a clean air lter. Do not allow any material to clog the lter, as this may cause
the heater to overheat. Never use without a lter. Always check, and if necessary, clean the lter before switching
WARNING: DO NOT COVER
In order to avoid overheating, do not cover the heater.
3 [EN]
the heater on. Do not allow oil, grease, or other contaminants to be drawn into the heater. Do not clean the heater
with organic solvents.
14. Never unplug the power cord without pressing the "ON/OFF button rst, as this could damage the unit. Never "
unplug the heater before the fan has stopped blowing. Always unplug the unit when not in use or moving location.
To disconnect from the power supply, grip the plug and pull from the power socket. Never pull by the cord.
15. Keep Electrical Components Dry: Never allow water inside the heater's electrical components. If these areas become
wet for any reason, thoroughly dry them before using the heater. If in doubt do not use the heater and consult a
qualied electrician or a Meaco approved engineer.
16. The operator must make the operating instruction available for the user and make sure that the user does understand
the manual.
17. To repair the unit, take it to a qualied service engineer. Repairs carried out by unqualied people may cause damage
to the unit or injury to persons or property and void the warranty.
ATTENTION: The heater is tted with a thermal cut out and a tip-over switch
so if the heater starts to overheat or if it falls over then it will automatically turn
o.
UK PLUG WIRING
Wiring Instructions: Should it be necessary to change the plug please note the wires in the mains
lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN LIVE –
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. The wire is the BLUE NEUTRAL N and must be connected to the terminal that is marked with the letter or
coloured . BLACK
2. The wire is the and must be connected to the terminal that is marked with the letter or coloured BROWN LIVE L
RED.
3. Always ensure that the cord grip is positioned and fastened correctly.
If a 13A (BS 1363) 13A (BS 1362) fused plug is used it must be tted with a fuse. If in doubt consult a qualied
electrician.
Wiring for a 13 Amp Plug (BS 1363)
1. GENERAL ADVICE
Before putting your heater into operation for the rst time, the instruction manual should be studied carefully.
Produktspecifikationer
| Varumärke: | Meaco |
| Kategori: | element |
| Modell: | Heat Motion Eye 1.8kW |
Behöver du hjälp?
Om du behöver hjälp med Meaco Heat Motion Eye 1.8kW ställ en fråga nedan och andra användare kommer att svara dig
element Meaco Manualer
5 Augusti 2025
element Manualer
- Gude
- Mellerware
- Beper
- Oceanic
- Perfect Aire
- Emko
- Blumfeldt
- Einhell
- Fagor
- Hatco
- Taurus
- Sogo
- Nordic Fire
- NEO Tools
- Heatstrip
Nyaste element Manualer
5 Augusti 2025
5 Augusti 2025
4 Augusti 2025
4 Augusti 2025
4 Augusti 2025
4 Augusti 2025
4 Augusti 2025
4 Augusti 2025
4 Augusti 2025
3 Augusti 2025