Megger MST210 Bruksanvisning
Läs gratis den bruksanvisning för Megger MST210 (4 sidor) i kategorin mätning. Guiden har ansetts hjälpsam av 16 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 8.5 recensioner. Har du en fråga om Megger MST210 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
MST210
Socket tester
User Guide
The Megger MST210 Socket Tester is designed to provide quick and easy indication of wiring errors which may be
present at a socket outlet. Using simple green and red LED’s, correct wiring can be verified with no need to isolate the
supply or disassemble the socket.
Simply plug the tester into the socket. If the wiring is correct, two green LED’s will illuminate. If either green LED does
not light or the red LED comes on, there is a wiring fault. By referring to the table below, the combination of LED’s
shown will indicate the wiring fault present. Technical advice may be obtained from Megger Product Support on +44
(0) 1304 502102.
Safety Warnings
NOTES: The MST210 cannot identify a Neutral to Earth
reversal. The Megger MST210 Socket Tester does not
eliminate the need for full electrical test of circuits as
specified by BS7671, and is supplementary to it.
The Megger MST210 Socket Tester is intended for initial
diagnosis of simple wiring faults, and any problem found
or suspected must be referred to a suitably qualified
electrician for repair.
Observe all of the safety information provided on the
product and in this User Guide
WEEE Directive
The crossed out wheeled bin symbol
on the instrument and on
thebatteries is a reminder not to
dispose of them with general
waste atthe end of their life.
Megger is registered in the
UK as a Producer of Electrical
and Electronic equipment.
The registration no is; WEE/
DJ2235XR.
Users of Megger products
in the UK may dispose of
them at the end their useful life
by contacting B2B Compliance
at ww.b2bcompliance.org.uk or by
telephone on 01691 676124. Users of
Megger products in other parts of the EU should contact
their local Megger company or distributor.
CATIV - Measurement category IV: Equipment connected
between the origin of the low-voltage mains supply
outside the building and the consumer unit.
CATIII - Measurement category III: Equipment connected
between the consumer unit and the electrical outlets.
CATII - Measurement category II: Equipment connected
between the electrical outlets and the user’s equipment.
Warning – Electric Shock Hazard
Contact with live circuits can result in severe injury or
death. Before use check the tester and pins for any sign
of damage. Do not use if the instrument is damaged or
broken in any way.
Do not use in damp or wet conditions
This unit is not designed to be used continuously for
more than 5 minutes. Do not leave plugged in to a live
socket for extended periods.
Do not cover vent slots
Suitable for use on 230 V ac 13A BS1363 socket outlets
only. Do not attempt to adapt it for any other use.
This product is maintenance free and contains no user-
serviceable components.
Do not attempt to disassemble.
Instructions for Use
1. Verify the operation of the
MST210 by plugging into a
known good 13A socket
before use.
2. Plug the tester into the
socket to be tested and
switch on.
3. Check the indication
displayed by the LED’s against
the table for diagnosis of the
wiring status.
Specifications
Indicators Single colour bright LED
Supply Rating 230V 50Hz
Current Draw 3mA max
Operating Temperature 0 to 40°C
Humidity < 95% non-condensing
Size 69mm x 67mm x 32mm
Weight 80g
Cleaning instructions:
Wipe clean with a dry cloth. Do not use water, chemicals
or detergents of any kind. Suitable for sale within the EU
Megger Limited, Archcliffe Road, Dover, Kent, CT17 9EN,
United Kingdom.
Produktspecifikationer
| Varumärke: | Megger |
| Kategori: | mätning |
| Modell: | MST210 |
Behöver du hjälp?
Om du behöver hjälp med Megger MST210 ställ en fråga nedan och andra användare kommer att svara dig
mätning Megger Manualer
9 Augusti 2025
3 Augusti 2025
3 Augusti 2025
2 Augusti 2025
2 Augusti 2025
2 Augusti 2025
2 Augusti 2025
2 Augusti 2025
2 Augusti 2025
2 Augusti 2025
mätning Manualer
- Autel
- Crowcon
- Osram
- Eastron
- SKS
- REV
- TFA
- Tempo
- ABB
- Stamos
- Stelzner
- Chauvin Arnoux
- Sonel
- National Geographic
- Mahr
Nyaste mätning Manualer
12 September 2025
12 September 2025
11 September 2025
11 September 2025
10 September 2025
10 September 2025
10 September 2025
10 September 2025
9 September 2025
8 September 2025