Megger TDR500/3 Bruksanvisning
Megger
Mätutrustning
TDR500/3
Läs gratis den bruksanvisning för Megger TDR500/3 (18 sidor) i kategorin Mätutrustning. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 10.5 recensioner. Har du en fråga om Megger TDR500/3 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/18
Page 1 1 of
M
TDR1000/3
TDR1000/3P
CFL510G
TDR500/3
Time Domain Reflectometers
User Manual
Page 3 3 of
G SAFETY WARNINGS
■ Safety warnings and precautions must be read and understood before the instrument is used. All Safety warnings and
precautions must be observed during use.
■ The circuit under test must be switched off, de energised, securely isolated - and proved safe before test connections are
made.
■ Use the correct lead se the Megger fused lead set must be used. Refer to the Test Lead selection t. On power systems page
in this user guide to identify the correct lead set.
■ The operator must verify that the circuit is safe before testing and take the appropriate precautions.
■ Ensure that hands remain behind guards of probes/clips when testing.
■ The instrument should not be used if any part of it is damaged. Also all test leads, probes and crocodile clips must be in
good order, clean and with no broken or cracked insulation.
■ Disconnect the test leads before removing the battery cover. The battery cover must be in place whilst conducting tests.
■ This product contains no user service parts.
■ All relevant safety procedures must be followed.
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY
TRAINED AND COMPETENT PERSONS
Page 4 4 of
Symbols
The following symbols are used on this instrument
G
CAUTION: RISK OF DANGER
t
EQUIPMENT PROTECTED THROUGHOUT BY DOUBLE INSULATION OR REINFORCED
INSULATION
c
EQUIPMENT COMPLIES WITH RELEVANT EU DIRECTIVES
EQUIPMENT COMPLIES WITH AUSTRALIAN EMC REQUIREMENTS (C tick) (NOT FOR SAFETY)-
THIS EQUIPMENT SHOULD BE RECYCLED AS ELECTRONIC WASTE
Produktspecifikationer
| Varumärke: | Megger |
| Kategori: | Mätutrustning |
| Modell: | TDR500/3 |
Behöver du hjälp?
Om du behöver hjälp med Megger TDR500/3 ställ en fråga nedan och andra användare kommer att svara dig
Mätutrustning Megger Manualer
29 December 2024
29 December 2024
23 September 2024
23 September 2024
21 September 2024
20 September 2024
20 September 2024
11 September 2024
10 September 2024
9 September 2024
Mätutrustning Manualer
- BJZ
- Testboy
- Be Cool
- Senseca
- P3 International
- Soehnle
- Toolland
- Bruder Mannesmann
- CSL
- Aeroqual
- Peak
- Siglent
- PCE Instruments
- Murideo
- Maximum
Nyaste Mätutrustning Manualer
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025
3 April 2025