Metra AX-BM90122 Bruksanvisning
Metra
Inte kategoriserad
AX-BM90122
Läs gratis den bruksanvisning för Metra AX-BM90122 (5 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 3.7 stjärnor baserat på 3 recensioner. Har du en fråga om Metra AX-BM90122 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/5
AX-BM90122
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 11/13/19 INSTAX-BM90122
Product Info
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections ............................................................2
Installation ............................................................. 3
Programming ......................................................... 3
BMW (with M.O.S.T. 25 amplifier) 2004-2013
• Provides accessory power (12 volt 10 amp)
• Retains R.A.P. (retained accessory power)
• Designed for amplified models
• Retains audio controls on the steering wheel
• Retains phone buttons (radio dependent)
• Retains factory features: date, time, temperature display
• Micro-B USB updatable
• AX-BM90122 interface
• AX-BM90122 amplifier interface
• ASWC-1 interface
• AX-BM90122 harness
• ASWC-1 harness
• 3.5mm adapter
APPLICATIONS
BMW
1-Series 2004-2013 3-Series 2005-2012
2
CONNECTIONS
From the aftermarket radio to the AX-BM90122 harness, connect the:
• wire to the ground wire.Black
• Yellow wire to the battery wire.
• Yellow wire (6’ long w/ fuse-holder) directly to the vehicles battery.
• wire to the accessory wire.Red
• Orange wire to the illumination wire (if applicable).
• wire to the power antenna turn-on wire.Blue
• Brown wire to the mute wire.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• wire to the VSS/speed sense wire.Blue/Pink
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire.
•
Tape off and disregard the following (8) wires, they will not be used in this application:
Gray, Gray/Black Green Green/Black Purple Purple/Black White White/Black, , , , , ,
• and RCA jacks to the full range amplifier output jacks.Red White
ASWC-1 harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls.
• Connect the wire to the chassis ground.Black
• Connect the wire to accessory power.Red
• For the radios listed below: Connect the
3.5mm adapter
to the male 3.5mm SWC jack from the
ASWC-1 harness. Any remaining wires tape off and disregard:
• Connect the steering wheel control wire, normally Eclipse: Brown Brown/White, to the wire
of the connector. Then connect the remaining steering wheel control wire, normally Brown/
White Brown, to the wire of the connector.
• Connect the steering wheel control Key 1 wire to the Metra OE: (Gray) Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Blue/Yellow Connect the wire to
the wire.Brown
• Connect the steering wheel control SWC-2 wire from the radio to the XITE: Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
• Universal “2 or 3 wire” radio: Connect the steering wheel control wire, referred to as Key-A or
SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel control
wire, referred to as Key-B or SWC-2, to the wire of the connector. If the radio Brown/White
comes with a third wire for ground, disregard this wire.
Note:
After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.
• Connect the 3.5mm jack from the ASWC-1 harness, into the jack on the For all other radios:
aftermarket radio designated for an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
3
REV. 11/13/2019 INSTAX-BM90122
With the key in the off position:
• Connect the AX-BM90122 harness AX-BM90122 interface to the .
• Connect the AX-BM90122 harness AX-BM90122 amplifier interface to the .
• Remove the dust cover from fiber optic port in the AX-BM90122 amplifier interface.
• Connect the factory fiber optic cable into the AX-BM90122 amplifier interface.
• Connect the AX-BM90122 harness to the wiring harness in the vehicle.
• Connect the ASWC-1 harness ASWC-1 interface to the , and then to the AX-BM90122 interface.
• Press and hold the Volume-Up button on the steering wheel.
• Turn the ignition on, the L.E.D. in the ASWC-1 interface will start flashing rapidly, which
means the ASWC-1 is looking for the vehicle and the radio.
Note:
If the L.E.D. did not start flashing rapidly, press the reset button for 3 seconds, while still
holding the Volume-Up button.
• After a few seconds the L.E.D. should stop flashing rapidly, and then go out for
approximately 2 seconds.
• After approximately 2 seconds there will be a series of 7 flashes, some short, and Green
some long. The long flashes represent the wires that are connected to the ASWC-1. The 3rd,
4th, 5th, and 6th flashes should be longer.
Tip:
Knowing this will help to troubleshoot, if need be.
• The L.E.D. will pause for another 2 seconds, and then flash up to 18 times depending on Red
which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.
• This is the end of the auto detection stage. Release from holding the Volume-Up button.
If the ASWC-1 detected the vehicle and the radio successfully, the L.E.D. will light up solid.
•
Test the steering wheel controls for proper operation. Refer to the ASWC-1 instructions online at
axxessinterfaces.com for customizing the buttons, if so desired
.
INSTALLATION
PROGRAMMING
PROGRAMMING
(CONT.)
L.E.D. feedback
The (18) L.E.D. flashes represent which brand radio the ASWC-1 is connected to. Each Red
flash represents a different radio manufacturer. For example, if you are installing a JVC radio,
the ASWC-1 will flash (5) times, and then stop. Following is a legend that dictates which Red
radio manufacturer corresponds to which flash.
L.E.D. feedback legend
1 flash - Eclipse (Type 1) †
2 flashes - Kenwood ‡
3 flashes - Clarion (Type 1) †
4 flashes - Sony / Dual
5 flashes - JVC
6
flashes -
Pioneer / Jensen
7 flashes - Alpine *
8 flashes - Visteon
9 flashes - Valor
10 flashes - Clarion (Type 2) †
11 flashes - Metra OE
12 flashes - Eclipse (Type 2) †
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBD
18 flashes - JBL
* Note:
If the ASWC-1 flashes (7) times, and you do not have an Alpine radio connected to Red
it, that means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm jack is
connected to the correct steering wheel jack/wire in the radio.
** Note:
The AX-SWC-PARROT is required (sold separately). Also, the Parrot radio must be
updated to rev. 2.1.4 or higher through www.parrot.com.
† Note:
If you have a Clarion radio and the steering wheel controls do not work, change the radio type to
the other Clarion radio type; same for Eclipse. Refer to the “Programming Information” document online
.
‡ Note:
If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC radio,
change the radio type to a Kenwood. Refer to the “Programming Information” document online
.
Produktspecifikationer
| Varumärke: | Metra |
| Kategori: | Inte kategoriserad |
| Modell: | AX-BM90122 |
Behöver du hjälp?
Om du behöver hjälp med Metra AX-BM90122 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Metra Manualer
3 April 2025
3 April 2025
3 April 2025
12 Mars 2025
24 Februari 2025
24 Februari 2025
14 Januari 2025
14 Januari 2025
2 Januari 2025
2 Januari 2025
Inte kategoriserad Manualer
- Cobra
- Leatt
- Medion
- Kemo
- Vicoustic
- 4ms
- Herma
- Texsport
- Profoon
- Oregon Scientific
- Uni-T
- DMax
- Infomir
- SilverStone
- CEDAR
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025