Microchip RN4871 Bruksanvisning


Läs gratis den bruksanvisning för Microchip RN4871 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 7.5 recensioner. Har du en fråga om Microchip RN4871 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
© Microchip Technology, Inc. 20 RN4870 v1.42 Release Notes 21
RN4870/ Firmware 71 1.42 Release Note
9/ / 01 2021
1 Overview
This release note provides details on the firmware Rev 1.42 that is released for the
RN4870 and RN4871 modules.
2 New Features
Rev 1.42 incorporates a new command to change the UART immediately
without the need for a reboot (unlike the SB command).
- SBI, <8-bit hex value>
- The input parameter is an 8-bit hex value in the range of 00 to 0B,
representing baud rate from 2400 to 921K as shown in table below.
-
Hex value
Baud rate
00
921000
01
460800
02
230400
03
115200
04
57600
05
38400
06
28800
07
19200
08
14400
09
9600
0A
4800
0B
2400
- Default: 03
- Example: SBI,07 //Set the UART baud rate to 19200
immediately
- Response: AOK //Success
- ERR //Syntax error or invalid parameter
3 Resolved Issues
Fixed ANSSI vulnerabilities
Fixed Sweyntooth vulnerabilities
Modified the SM command to limit the range of timers 2 and 3. The value can
be set for these timers should be between 0 to 0x0FFE.


Produktspecifikationer

Varumärke: Microchip
Kategori: Inte kategoriserad
Modell: RN4871

Behöver du hjälp?

Om du behöver hjälp med Microchip RN4871 ställ en fråga nedan och andra användare kommer att svara dig