Oliveri SS2525 Bruksanvisning
Läs gratis den bruksanvisning för Oliveri SS2525 (4 sidor) i kategorin Kran. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 7.5 recensioner. Har du en fråga om Oliveri SS2525 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
Before attempting any work involving mains water supply lines, ensure the water supply is shut off.
Stop valves (preferably with filters) must be used when installing your Oliveri mixer to allow isolation. (not
supplied with mixer). Failure to do so where required will void warranty.
This mixer tap is already pre-assembled and tested. Do not disassemble, as this may void the warranty.
This mixer tap must be installed in accordance with these instructions.
Essente stainless steel goose neck pull out mixer
SS2525
Where water pressure exceeds 500kPa, a pressure reducing device is required to be installed. Note that
water pressure overnight can reach 150% of the daytime pressure.
CARE & MAINTENANCE
Unscrew and clean the spout aerator periodically - especially if you notice a drop in water pressure.
The polished chrome plate finish on your Oliveri mixer tap will resist stains and dirt build up.
Clean with a soft cloth and warm soapy water as necessary - rinse and dry after cleaning. Avoid using abrasive
or acid based cleaning products.
WARRANTY
This mixer tap is warranted to be free from manufacturing defects for a period of 10 Years: 5 years only (parts
& labour) plus an additional 5 years on the Cartridge (parts only), when used in a domestic situation.
This warranty does not cover against normal wear and will be voided if the product is misused or not
installed in accordance with these instructions. Note: Fitting spout-attached devices, including water filters,
to this mixer will void warranty.
In the event this product is rendered obsolete and a replacement product is required, Tasman Sinkware
reserves the right to supply a product of equal substitution at their discretion.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to
be of acceptable quality and the failure does not amount to a major failure.
SERVICE
If the problem represents a danger, or damage to property may occur, immediately shut off the water supply.
If the mixer tap requires servicing, please contact your plumber (preferably the one who installed it).
Most problems occur due to contaminated supply lines or water pressure exceeding 500kPa.
If the Plumber is satisfied that the problem is not due to poor installation, contact T2 Services Pty Ltd for
assistance on:
Ph: (07) 5596 0738
Fax: (07) 5527 3353
Email: oliveri@t2services.com.au
If a warranty service call finds that the mixer tap is not at fault, T2 Services Pty Ltd reserves the right to pass
on any callout fee to the householder.
THIS MIXER TAP MUST BE INSTALLED BY A LICENSED PLUMBER IN
ACCORDANCE WITH LOCAL REGULATIONS
This Oliveri tap is manufactured to standard AS/NZS 3718.
Note: Installation of aerators containing flow regulators.
Upon re-installation, the aerator should be tightened with an aerator key to prevent removal by hand.
Note: Ceramic Cartidges - Warranty claims will not be honoured where the ceramic cartridge has
malfunctioned due the the presence in the water supply of;
- Copper tube pieces, sand, dirt or stones
- Thread tape
- Other objects not normally present in potable water supplies.
- Do not remove the cartridge from the body as it has been pressure tested and tightened to a
specific torque.
Technical Data
Installation Instructions
TF 182b - SS2525 installation instructions.pdf
MAX OPERATING PRESSURE: ..............................................................5 bar (500kPa)
RECOMMENDED OPERATION PRESSURE: ..........................................1.5-5 bar (150-500kPa)
MAX HOT WATER TEMPERATURE: .....................................................65°C
RECOMMENDED HOT WATER TEMPERATURE: ..................................50°C
Produktspecifikationer
| Varumärke: | Oliveri |
| Kategori: | Kran |
| Modell: | SS2525 |
Behöver du hjälp?
Om du behöver hjälp med Oliveri SS2525 ställ en fråga nedan och andra användare kommer att svara dig
Kran Oliveri Manualer
8 April 2025
8 April 2025
2 April 2025
2 April 2025
26 December 2024
26 December 2024
26 December 2024
25 September 2024
25 September 2024
21 September 2024
Kran Manualer
- Brizo
- Delta
- Inventum
- Axor
- American Standard
- Omnires
- Puretec
- WillieJan
- Viidako
- Concept
- Peerless-AV
- Jacuzzi
- Franke
- SaniSupreme
- Karran
Nyaste Kran Manualer
20 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
19 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025