Olympia RM 10 mini Bruksanvisning

Läs gratis den bruksanvisning för Olympia RM 10 mini (1 sidor) i kategorin Rökdetektor. Guiden har ansetts hjälpsam av 19 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 7 recensioner. Har du en fråga om Olympia RM 10 mini eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

11-1612-169-1610-16

7-168-165-166-16

Install at a distance of at least 50 cm from uorescent

light sources.

50 cm

Fig.8

smoke alarm

Fig.7

the install distance should be 61cm at least from the

corner of the wall

To mount the smoke alarm, proceed as follows:

– Use the screws to x the base plate in the place

chosen. Pay attention to the gure above(Fig.4-Fig.8).

– Gently tighten the alarm onto the base plate.

– Mount the alarm in the centre of the ceiling of the room.

– Do not mount the alarm in a place which is dicult to

reach.

– The smoke alarm may not be painted.

Fig.9

Twist to tighten

Twist to loose

SCREWS

SCREWS

Bracket

10-YEAR BATTERY

SMOKE ALARM

Read the instruction manual before usage.

1. General

This is a smoke alarm device using the photoelectric

principle. It’s designed for detecting smoke in the air,

while not for sensing heat, gas or ame. If the smoke

alarm is properly mounted and maintained, it will be

activated at the very start. The smoke alarm is

designed to detect smoke, it can not prevent a re.

Please read the instruction manual carefully before you

use this smoke alarm.

The “device” hereinafter stands for “smoke alarm

device”.

2.Device & Spare parts

1

2

3

1-Main unit

2-user manual

3-Screws and dowels ( 2

sets)

Fig.1

2-16

3.General gure

4.Power on

Fig.2

LED indicator

Test/Hush button

Smoke inlet

Back cover

Fig.3

3-16

Unscrew the bottom cover, remove the small magnet, the

power is switched on(Fig3).

CAUTION: built-in Lithium battery of product can not be

replaced. Standby time is 10 years at normal use

condition.

5.Device specications：

Dimension：Φ45x42 mm

Weight50g：

Operate Temperature0 -50 ：℃℃

Working voltage3V：

Standby current：≤7uA

Humidity10%-90%：

Service environment: house supply

Designed life10 year：

Note: If the product is energized, put the small magnet

back in place to switch into power o. (If there is no LED

lights ashing and successive “Beep” alarm signal given

when long press the Test/Hush button, it indicates the

device is power o.)

The device is energized and working if it’s with LED

indicator ashing and continuous Beep alarm sound by

pressing the Test/Hush button.

4-16

15-1613-1614-16

6.Mounting

The smoke alarm should be mounted in the following

places:

• at least one in each room

• one on each oor, if the oor is too long, there shall be

mounted two or more smoke alarms

• in the hallway, in the staircase

• in the living room

• in each bedroom

• in the storage room or spaces with electric

equipment

The alarm may not be mounted in

the following places:

• a room in which the temperature can drop

below 0°C or rise above 50°C

• in damp rooms

• in front of doors or windows

• near a ventilator or radiator.

Smoke alarm for minimal protection

Smoke alarm for extra protection

Fig.4

1. Bedroom

2. Bedroom

3. Staircase

4. Bedroom

5. Livingroom

6. Kitchen

7. Entrance

8. Hobby area

9.Guest bathroom

10. Bathroom

11. Storage

12. Garage

Fig.5

Do not install in the tip of a

sloping ceiling,as smoke-free air

can collect in these areas. If

the ceiling slopes over 30°

and has a total height of

up to 6 m, a distance of

30-50 cm from the tip

is to be observed. If the slope is up to 45° the

smoke alarm can be installed on the slope.

Fig.6

30°

30 - 50 cm

6 m

The “Test/Hush” button is long pressed till the device

gives audible alarm continuously “beep” and visible

alarm LED blinking when the test is going on. When

the “Test/Hush” button is released, the audible and

visible alarm stops, meanwhile the device goes to

hush mode. Repeat the above steps to exit Hush

mode.

7. Functionality

7.2 Standby mode

The device goes to standby mode once powered on,

with once LED blinking every 344 second

Fig.10

7.1 This device is capable of self-regulating to long

term drift of photoelectric chamber to ensure

long-time stability of device

7.3 Test

Fig.11

~

DI DI DI DI ~

7.4 Hush mode

1. In the standby mode, press the “Test/Hush” button,

the device enters hush mode.

2. In the state of alarm, press the “Test/Hush” button,

the device enters hush mode.

3. The whole process of the hush mode lasts for 9

minutes.

4. In the hush mode, hold the “Test/Hush” button until

Fig.12

acoustic alarm signal is emitted, the device exits the

hush mode and returns to standby mode.

Attention:

1. No matter mode of standby or alarm, press the

“Test/Hush” button, the device enters hush mode. LED

indicator light ashes once every 10 seconds. Hold the

“Test/Hush” button until acoustic alarm signal is

emitted, the device exits the hush mode.

2. If long press the Test/Hush button to make the

device emit alarm sound signal, then the device won’t

enter into hush mode. The device will enter into hush

mode only if press the Test/Hush button shortly.

3. When the device is in standby mode or hush mode,

please pay close attention to the LED ashing time

interval, if LED ashing once every 10 seconds, it’s in

hush mode, while if LED ashing once every 344

seconds, it’s in standby mode.

4. On hush mode, the device gives normal alarm when

the smoke concentration in the ambience is more than

4 times of alarming value.

every 10 seconds

7.5 Low battery

7.6 Malfunction or end-of-life

When the device is on low-battery condition

(2.4v±0.1v), it sounds once “beep” every 43

seconds.

When the device malfunctions or is to be end

of life, it sounds continuously “beep” every 43

seconds.

Fig.13

Fig.14

DI DI DI

DI

Please replace device under conditions of

malfunction, end of life or low-battery warning.

IMPORTANT

When the device is alarming or on standby, pressing

the “Test/Hush” button once, it goes to hush mode;

pressing the “Test/Hush” button once again, it exits

hush mode.

Placing a smoke alarm is a part of your re protection,

just as re extinguishers, emergency ladders, ropes,

but also your choice in the use of building materials for

renovation. Always ensure that there is an evacuation

plan, discuss this with your children. Ensure that each

room can be left without opening the door, e.g. by the

window. If there is any question as to the cause of an

alarm, it should be assumed that the alarm is due to an

actual re and the dwelling evacuated immediately.

8. Precautions for use

• Test weekly

• Do not paint

• Not use this device in dusty or smoky ambience.

• Both designed device lifetime and battery standby

time (including test weekly) is 10 years. The battery

service time decreases if frequent alarm or long time

alarm.

• This device is not a device for re rescue or re

prevention, but an alarm to warn escape or notify

reman when there is a re accident with smoke

arisen. Hence it’s necessary to take precautions

against re, allocating like extinguisher, emergency

ladders and re blanket.

• The user with hearing disorder can’t make aware of

audible alarm when this device is used, so we

recommend this kind of users wireless or wired

interconnected smoke alarm with ash light indication.

• WE can never be made liable for loss and / or

damage of whatever nature, including incidental and /

or didn't use it according to the instruction and/ or

consequential loss, arising from the fact that the signal

from the smoke alarm did not sound during smoke or

re.

0086-CPR-550646

RM mini User Manual10

Guarantee

Dr Customer, ea

we are plshay have csenhis eipmt.eaed tt ouho tquen

In case oa defecplease return t vicether thef t, hede toge

with receip original cki material to point thet andpang the

of-sale.

10-YEAR BATTERY

SMOKE ALARM

Read the instruction manual before usage.

0086-CPR-550646

RM mini User Manual10

Produktspecifikationer