Omnitronic HM-105 Bruksanvisning

Läs gratis den bruksanvisning för Omnitronic HM-105 (2 sidor) i kategorin högtalare. Guiden har ansetts hjälpsam av 12 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 6 recensioner. Har du en fråga om Omnitronic HM-105 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Charger for HM-105

The switch mode power supply charger serves for quick and easy charging ofthe rechargeablebatteries

of the hand-held microphone, whichis a componentof the PAsystem.

Uncomplicatedpower supply for microphone

Average charging time approx. 4 hours(for 1300 mArech. Batteries)

Switch mode power supply(100-240 VAC, 50/60 Hz)

100-240 V AC,50/60 Hz

HM-105 W.A.M.S.-05

HM-105

Safety Instructions

Before yourinitial start-up,please makesure that thereare notransport damages. Shouldthere be

any,do not take the device into operation and immediately consult your dealer.

Operate the device only after having familiarized with itsfunctions. Do not permit operation by

personsnot qualified for operating the device.

Protect the device against humidity and heat. Keep away from heatersand other heating sources!

The charger is allowedto beoperated with an alternatingcurrent of. The

charger falls under protection class 2 and was designed for indoor use only.

Only use thecharger with the microphone.

Caution!Make sure there are rechargeable batteries insterted into the microphone. If non-

rechargeable batteriesare charged, leakage or explosionmay result.

Only insert rechargeablebatteriesofthe same type into the microphoneandreplacethe batteries in

pairs.

For cleaning,use asoftlint-freeand moistenedcloth. Neveruse alcohol orsolvents!Disconnect from

mains first.

There areno serviceable partsinsidethe device. Maintenance and service operationsare onlyto

be carried out by authorized dealers.

Damage, caused by manual modificationson the device are not subject to warranty. If the device

is used for other purposes than originally intended or ifit is notcorrectly connected, the product

may sufferdamages and theguarantee becomes void.

HM-105

Connections

Technical Specifications

When thebatteriesaregoingflat,thebattery symbolonthe microphone's LCDscreen starts flashing.

In thiscase,turnoffthemicrophone andcharge the batteries.Recharging timefor discharged

batteries is 4hours (with 1300mAbatteries).

Pressdown the grooved latch of the colored cap and remove the cap.

Connectthe chargerforthetothe charging contactofthemicrophoneandthe mains

plug to a mainssocket.Thus,the charging procedure is started.

During the charging,the microphone isdeactivated and can not be operated.

If all three bars inthe batterysymbolare displayed onthemicrophone'sLCD, thebatteries are

fully loadedand charging is completed.

If possible,always use theentire capacityofthe batteries.Short discharging/recharging cycleswill

reduce the batterie's capacity.

HM-105

Powersupply:.....................100-240 V AC, 50/60Hz~/0.3 A

Outputcurrent:...................2.0 A

Output voltage:..................5 V/DC

Recharging time:.................approx 4 hours(1300 mArech.batteries)

Dimensions(H x W x D):......80 x 75 x 25 mm

Weight:...............................110 g

Please note: Every information is subject tochange withoutprior notice.15.11.2007 ©

www.omnitronic.com

13107988_V_1_0.DOC

© Copyright

Nachdruck verboten!

Reproduction prohibited!

CHARGER

USER'S MANUAL

Accessory HM-105

Charger for HM 05

-

HM-105

charger

charging contact

CONNECTION

Produktspecifikationer