PAC GMRVD2 Bruksanvisning

Läs gratis den bruksanvisning för PAC GMRVD2 (3 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 1.5 recensioner. Har du en fråga om PAC GMRVD2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/3
Overhead LCD retention cable for
GMLAN Full Size Trucks & SUVs Rear Seat Entertainment (RSE)
(When keeping the factory Head Unit See Reverse Side for Instructions)
Video Input
Right Audio Input
Left Audio Input
Video Output
Right Audio Output
Left Audio Output
Audio / Video Input
From Rear Panel
Audio / Video Output
to Overhead LCD
Video
Left Audio
Right Audio
GMRVD2
The GMRVD2 is a plug and play cable that routes the audio and video signals to
the Rear Seat Entertainment (RSE) LCD. The audio and video inputs located in the
rear of the center console are also terminated as RCA jacks behind the radio at this
connector.
Note: This cable is intended for use in conjunction with an RP5-GM32 to retain all
safety and convenience systems. The vehicle should be equipped with an overhead
LCD and IR system, in which the DVD player was part of the AM/FM/CD receiver.
The RP5-GM32 is needed to power the IR headphone system.
When using a headunit with source control (A/V inputs and A/V outputs) - Connect the cables labeled Audio/
Video Input from Rear Panel to an A/V input (i.e. A/V 1 in, A/V 2 in). The cables labeled Audio Video Output to
Overhead LCD will then connect to the A/V output of the new source unit. The single black wire is a shield, connect
this to ground.
When using a standalone DVD player (only A/V outputs) - In this case, connect the A/V outputs to the cables
labeled Audio/Video Output to Overhead LCD. The rear panel A/V inputs will not be used and the black shield wire
should be connected to ground.
Pacic Accessory Corporation - Santa Ana, CA 92705
support@pac-audio.com • 866-931-8021 • www.pac-audio.com
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the GMRVD2 be
held liable for consequential damages sustained in connection with the GMRVD2. The manufacture and
it’s distributors will not, nor will they authorize any representative or any other individual to assume
obligation or liability in relation to the GMRVD2 other than its replacement.
GMRVD2
The GMRVD2 is a plug and play cable that allows aftermarket monitors and IR headphones to be
connected to the factory entertainment system. The GMRVD2 is connected behind the factory head unit.
Aftermarket
Monitor
Adding Aftermarket Monitors to
the Factory Entertainment System
(When Replacing the Factory Head Unit See Reverse Side for Instructions)
When using an aftermarket monitor, connect the cables labeled Audio Video Output to Overhead LCD to the aftermarket Monitor video
input. If installing aftermarket IR headphones, connect the RED and WHITE RCAs to the audio input of the aftermarket IR headphones. The
cables labeled Audio Video input From Rear Panel are not used.
Pacic Accessory Corporation - Santa Ana, CA 92705
support@pac-audio.com • 866-931-8021 • www.pac-audio.com
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the GMRVD2 be
held liable for consequential damages sustained in connection with the GMRVD2. The manufacture and
it’s distributors will not, nor will they authorize any representative or any other individual to assume
obligation or liability in relation to the GMRVD2 other than its replacement.
Video Input
Right Audio Input
Left Audio Input
Audio / Video Input
From Rear Panel
Video Output
Right Audio Output
Left Audio Output
Audio / Video Output
to Overhead LCD
Rev: 042613
Overhead LCD retention cable for
GMLAN Full Size Trucks & SUVs Rear Seat Entertainment (RSE)
(When keeping the factory Head Unit See Reverse Side for Instructions)
Video Input
Right Audio Input
Left Audio Input
Video Output
Right Audio Output
Left Audio Output
Audio / Video Input
From Rear Panel
Audio / Video Output
to Overhead LCD
Video
Left Audio
Right Audio
GMRVD2
The GMRVD2 is a plug and play cable that routes the audio and video signals to
the Rear Seat Entertainment (RSE) LCD. The audio and video inputs located in the
rear of the center console are also terminated as RCA jacks behind the radio at this
connector.
Note: This cable is intended for use in conjunction with an RP5-GM32 to retain all
safety and convenience systems. The vehicle should be equipped with an overhead
LCD and IR system, in which the DVD player was part of the AM/FM/CD receiver.
The RP5-GM32 is needed to power the IR headphone system.
When using a headunit with source control (A/V inputs and A/V outputs) - Connect the cables labeled Audio/
Video Input from Rear Panel to an A/V input (i.e. A/V 1 in, A/V 2 in). The cables labeled Audio Video Output to
Overhead LCD will then connect to the A/V output of the new source unit. The single black wire is a shield, connect
this to ground.
When using a standalone DVD player (only A/V outputs) - In this case, connect the A/V outputs to the cables
labeled Audio/Video Output to Overhead LCD. The rear panel A/V inputs will not be used and the black shield wire
should be connected to ground.
Pacic Accessory Corporation - Santa Ana, CA 92705
support@pac-audio.com • 866-931-8021 • www.pac-audio.com
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the GMRVD2 be
held liable for consequential damages sustained in connection with the GMRVD2. The manufacture and
it’s distributors will not, nor will they authorize any representative or any other individual to assume
obligation or liability in relation to the GMRVD2 other than its replacement.
GMRVD2
The GMRVD2 is a plug and play cable that allows aftermarket monitors and IR headphones to be
connected to the factory entertainment system. The GMRVD2 is connected behind the factory head unit.
Aftermarket
Monitor
Adding Aftermarket Monitors to
the Factory Entertainment System
(When Replacing the Factory Head Unit See Reverse Side for Instructions)
When using an aftermarket monitor, connect the cables labeled Audio Video Output to Overhead LCD to the aftermarket Monitor video
input. If installing aftermarket IR headphones, connect the RED and WHITE RCAs to the audio input of the aftermarket IR headphones. The
cables labeled Audio Video input From Rear Panel are not used.
Pacic Accessory Corporation - Santa Ana, CA 92705
support@pac-audio.com • 866-931-8021 • www.pac-audio.com
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the GMRVD2 be
held liable for consequential damages sustained in connection with the GMRVD2. The manufacture and
it’s distributors will not, nor will they authorize any representative or any other individual to assume
obligation or liability in relation to the GMRVD2 other than its replacement.
Video Input
Right Audio Input
Left Audio Input
Audio / Video Input
From Rear Panel
Video Output
Right Audio Output
Left Audio Output
Audio / Video Output
to Overhead LCD
Rev: 042613

Produktspecifikationer

Varumärke: PAC
Kategori: Inte kategoriserad
Modell: GMRVD2
Färg på produkten: Zwart
Bredd: 318 mm
Djup: 25 mm
Höjd: 224 mm
Användarmanual: Ja
Blåtand: Nee
Nuvarande: 1 A
Beeldscherm: LED
Skärm diagonal: 13.3 "
Upplösning: 1280 x 800 Pixels
Pekskärm: Nee
Ljudformat som stöds: MP3, WMA
Videoformat som stöds: AVI, MPEG4
Typ av anslutningskontakt: Nee
Placeringsstöd: Horizontaal
Ethernet LAN: Nee
Typ av strömkälla: DC
Integrerad minneskortläsare: Ja
Kompatibla minneskort: MMC, SD
Inkluderar AC-adapter: Ja
LED-bakgrundsbelysning: Ja
Dagordning: Ja
Antal USB 2.0-portar: 1
Inbyggda högtalare: Ja
Antal inbyggda högtalare: 2
Gränssnitt: USB 2.0
3D: Nee
Bildformat som stöds: JPG
Bildförhållande: 16:9
Plug and play: Ja
Typ av bakgrundsbelysning: LED
Klockfunktion: Ja
Spela filmen: Ja
Dokumentformat som stöds: TXT
Visning av klocka/datum: Ja
USB direktuppspelning: Ja
Wifi: Nee
AC-ingångsspänning: 110 - 240 V
AC-ingångsfrekvens: 50/60 Hz
Antal-produkter-ingår: 1 stuk(s)

Behöver du hjälp?

Om du behöver hjälp med PAC GMRVD2 ställ en fråga nedan och andra användare kommer att svara dig