PAC RadioPRO 3 RP3-GM12 Bruksanvisning

Läs gratis den bruksanvisning för PAC RadioPRO 3 RP3-GM12 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 2 recensioner. Har du en fråga om PAC RadioPRO 3 RP3-GM12 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

RP3-GM12

Radio Replacement Interface for General Motors Vehicles

Pacifi c Accessory Corporation® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com

©2013 Pacifi c Accessory Corporation

www.pac-audio.com

Rev. 11-22-13

Pifi ACti

3

3

3

Introduction & Features

Wiring Connection Chart

Illustration / Schematic

The RP3-GM12 interface allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using

this interface will retain factory features such as Warning Chimes when the original radio is removed. The RP3-GM12 provides

data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse trigger and

parking brake. The RP3-GM12 also provides a secondary output for adding an optional PAC Steering Wheel Control (SWC)

retention interface (SWI-RC, SWI-PS, SWI-JACK, SWI-ECL2 or SWI-X).

Red / WhiteParking Brake

Output (-)*

Purple / WhiteVehicle Speed

Output*

Blue / WhiteAmp Turn On Input

RedAccessory Output

(10 amp)

Orange / WhiteIllumination Output

(+)*

GreenReverse Output (+)*

Interface Connector

YellowBattery +12v

Black Ground

BlueAntenna On Input

WhiteFront L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

GreenRear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Vehicle Connector

*Not all radios will have these

connections. Please insulate

these wires when not used.

Chime Volume Adjustment

Aftermarket Radio

Connections

Connect to SWC

Interface. Program

for Version 2.

To optional SWC interface

To Vehicle

Connector Acc On

LED

Important Notes

1. For BOSE systems, the recommended line level input is between 2-4 volts from the aftermarket radio.

2. To prevent over driven audio when installing into a vehicle with a BOSE system and the aftermarket radio does not have low

level outputs then an LOC (part # SOEM-4 or LP3-4) is recommended to match the input voltage.

3. Use the 4 position selector switch located on the side of the interface to select the best chime output for your specifi c installation.

Produktspecifikationer