Panasonic PT-VW430U Bruksanvisning
Läs gratis den bruksanvisning för Panasonic PT-VW430U (4 sidor) i kategorin Projektor. Guiden har ansetts hjälpsam av 30 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 15.5 recensioner. Har du en fråga om Panasonic PT-VW430U eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/4
CARE LABEL
Always check the care labels, especially when placing garments
in the tumble dryer for the rst time. Below are the most
commonly used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
THANK YOU FOR BUYING A HOTPOINT PRODUCT.
In order to receive a more complete assistance, please
register your product on www.hotpoint.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety
Instructions.
FIRST TIME USE
Remove all the tapes used to hold items on the machine.
Before you use it, clean the inside of the drum to remove any
dust that could have accumulated during transport. Slight odour
or vapour may be found if you open the door during its rst use,
this is normal and should only last a few minutes.
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dryer is properly
connected, either to the dryers's water tank or to your domestic
drainage system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying cycle.
- remember to clean your condenser unit regularly
(monthly).
- remember to clean your lter after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door lter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items.
3. Close the door.
4. Press the "On/O" button.
5. Select the most suitable programme
for the type of fabric in that
load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Pull the load out
immediately to prevent the formation of creases on laundry.
9. Turn the machine o by pressing the "On/O" button, open the
door and pull the clothing out. If the machine is not switched o
manually, after about a quarter of an hour from the end of the
cycle , the appliance turns o automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
TRANSPORT AND HANDLING
Never lift the dryer by holding on to its top side.
1. Unplug the dryer
2. Remove the water from the water tank completely.
3. Make sure that door and water tank are properly closed.
4. If the drain hose is connected to your drainage system, re-connect
it to the back of the dryer (see "Installation" section in the Safety
Instructions).
OPENING THE DOOR DURING THE CYCLE
Laundry can be checked while the drying cycle runs and any
garments already dry can be removed, while drying continues for
the remaining items. After closing the door, press the "Start/Pause"
button to resume machine operation.
CONTROL PANEL
1 ON/OFF Button (hold to Reset)
2 Programme Selection Knob
3 Start/Pause
Options Buttons
4 Crease Care
5 Dryness Level
6 Start Delay
7 Timed Drying
8 Cycle End Signal
9 Gentle (hold for Key Lock)
10 Rapid hold to Mute)(
INDICATORS
Dryness Level: Iron Dry - Hanger Dry - Cupboard Dry - Extra Dry
Programme Status: ENDDrying - Cool Down - End of Cycle
Empty water tank Clean door lter - - Clean the condenser unit
Refer to the troubleshooting section: Failure: Call after sales service.
END
EN
EN
EN
END
D
D
D
1
3
2
4
10
8
9
5 6 7
h
h
h
h
h
h
Produktspecifikationer
| Varumärke: | Panasonic |
| Kategori: | Projektor |
| Modell: | PT-VW430U |
Behöver du hjälp?
Om du behöver hjälp med Panasonic PT-VW430U ställ en fråga nedan och andra användare kommer att svara dig
Projektor Panasonic Manualer
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
24 Oktober 2024
17 Juli 2024
16 Juli 2024
Projektor Manualer
Nyaste Projektor Manualer
8 Januari 2025
24 Oktober 2024
10 September 2024
18 Juli 2024
18 Juli 2024
18 Juli 2024
18 Juli 2024
16 Juli 2024
16 Juli 2024
16 Juli 2024