Panduit NK5E88MBUY Bruksanvisning


Läs gratis den bruksanvisning för Panduit NK5E88MBUY (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 5.5 recensioner. Har du en fråga om Panduit NK5E88MBUY eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
N KET EY
NETWORK COMPONENTS
CONTRACTOR GRADE
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014 NK178C
Page 1 of 2
NetKey Keystone Style Jack Modules
Part Numbers: NK366M**Y, NK388M**Y, NK588M**Y, NK5E88M**Y, NK5E88M**Y-Q
1
2
3
4
5
6
7B
Straighten conductors and arrange in proper color sequence.
Remove 3" (76.2mm) of cable jacket and untwist pairs.
Pull conductors until outer jacket is inside cap. Bend up 90°. Cut conductors on an angle and insert into cap.
Snap cap squarely on housing until it clicks.Trim conductors flush with cap using wire snipping tool (CWST).
NOTE: Cable jacket is inside the cover.
Use Snap Tool (7A) or standard Slip Lock Pliers (7B).
Apply pressure to cap until it clicks again. Cap must be flush on
housing.
Termination Cap Removal Instructions
--- FOR USE IN KEYSTONE STYLE OUTLETS AND PATCH PANELS ONLY ---
--- OVER FOR KEYSTONE STYLE PANEL OPENING REQUIREMENTS ---
Slide screwdriver under cap to separate from housing.Push forward and down against latch at end of guide ramp until cap releases.
1
2
7A
** Denotes jack module color code.


Produktspecifikationer

Varumärke: Panduit
Kategori: Inte kategoriserad
Modell: NK5E88MBUY

Behöver du hjälp?

Om du behöver hjälp med Panduit NK5E88MBUY ställ en fråga nedan och andra användare kommer att svara dig