Porter-Cable 42690 Bruksanvisning

Porter-Cable Inte kategoriserad 42690

Läs gratis den bruksanvisning för Porter-Cable 42690 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 32 personer och har ett genomsnittsbetyg på 4.3 stjärnor baserat på 16.5 recensioner. Har du en fråga om Porter-Cable 42690 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/2

PORTER-CABLE® 4825 Highway 45 North, Jackson, TN 38305 (1.888.848.5175) deltaportercable.com• • •

N030592 - JUNE09 - REV0

42690 (TYPE 2) ROUTER EDGE AND CIRCLE CUTTING GUIDE

IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY

PORTER-CABLE TOOL, CALL US TOLL FREE AT: 1.888.848.5175

SAFETY INSTRUCTIONS

To reduce the risk of injury, read the tool instruction manual

before using any accessory. Failure to heed these warnings may result in

personal injury and serious damage to the tool and the accessory. When

servicing this tool, use only identical replacement parts.

To reduce the risk of injury, turn unit off and disconnect it

from power source before installing and removing accessories, before

adjusting or when making repairs.

An accidental start-up can cause injury.

CARTON CONTENTS (FIG. 1)

• Edge Guide body

• (2)#1 rods (shortest)

• (2)#2 rods

• (2)#3 rods (longest)

• (2)Short screws (B)

• (2)Larger screws (C)

• Pivot pin ( ) for making H

circles

USING 42690 AS AN EDGE GUIDE:

1. Attach appropriate rods to edge guide as defined below:

• For all 690 (Fig. 1) and 890 series routers (except 6911 "D"

handle): Screw rods marked as #1 into threaded holes marked #1 in

block end (Fig. 1A).

• For 6911 "D" handle (not shown) : Screw rods marked as #2 into

threaded holes marked as #2 in the block end (Fig. 1A).

• For 7500 series routers (not shown): Screw rods marked as #3 into

threaded holes marked as #3 in the block end (Fig. 1A).

2. Attach edge guide to router with enclosed screws. Smaller screws (B)

Fig. 2 are for 690 and 890 series routers and larger screws (C) Fig. 1 are

for 7500 series routers.

3. For fast adjustment, loosen both lock nuts (D, E) and slide fence to

desired position.

4. For fine adjustment, tighten lock nut (D) and turn fine adjust knob (F)

until fence is in exact position. Micrometer scale (G) can be rotated and

zeroed to index mark. One complete rotation moves fence 1/16" (1.6

mm).

USING 42690 AS CIRCLE GUIDE

1. Remove the sheet metal bracket (I) Fig. 3 from the guide by removing

three screws (J).

2. Thread the pivot pin (H) Fig. 4 into the middle hole as shown. Tighten

with a flat head screwdriver.

3. Attach edge guide to router as described under Using 42690 As An

Edge Guide.

4. Drill a perpendicular 1/4" (6.35 mm) hole at the intended center of the

workpiece to be routed.

5. Install the bit into the router.

Follow the instructions in your router owner’s manual for

changing bits and operating the router. Be sure to read all safety rules

regarding the proper use of the router.

6. Adjust the distance from the pin to the bit to your desired radius.

7. Place pin (H) Fig. 5 into 1/4" (6.35 mm) hole in workpiece. This is used

as the pivot point for the cut to be made.

8. For through cuts, it is recommended that scrap material be placed

under the workpiece to prevent unnecessary damage. A plunge router

is recommended for the application.

9. Route in a clockwise direction, as shown in Figure 6.

10. Refer to chart below for circle size capacities when using various

PORTER-CABLE routers:

ROUTER BASE MIN MAX

D handle #6911 9" (228.6 mm) 27" (685.8 mm)

690 ﬁxed base #1001 9" (228.6 mm) 27" (685.8 mm)

690 plunge base #6931 9" (228.6 mm) 27" (685.8 mm)

890 ﬁxed base #8901 9" (228.6 mm) 27" (685.8 mm)

890 plunge base #8931 10" (254 mm) 28" (711.2 mm)

7500 series routers 10-1/2" (266.7 mm) 28-1/2" (723.9 mm)

11. Circle grooves are also possible, as shown in Figure 7.

FIG. 1

FIG. 2

FIG. 6

FIG. 7

2 1

FIG. 1A

FIG. 3

FIG. 4

FIG. 5

Produktspecifikationer

Varumärke:	Porter-Cable
Kategori:	Inte kategoriserad
Modell:	42690
Färg på produkten:	Zwart
Typ av strömkälla:	AC, Cigar lighter
Inbyggt batteri:	Nee
Kompatibilitet:	PSP
Typ-av-laddare:	Auto, Indoor
Laddare kompatibilitet:	Draagbare game console