Princeton Tec Apex Bruksanvisning
Princeton Tec
Ficklampa
Apex
Läs gratis den bruksanvisning för Princeton Tec Apex (2 sidor) i kategorin Ficklampa. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 9.5 recensioner. Har du en fråga om Princeton Tec Apex eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
Princeton Tec
PO Box 8057, Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2017 Princeton Tec
www.princetontec.com
Operating Instructions
Notice d’utilisation et d’entretien
Bedienungsanleitung
TM
APEX
RECHARGEABLE
LED HEADLAMP
Green
above 50%
Yellow
49 - 20%
Red
below 20%
Color Battery Capacity*
ENGLISH
Configurations / Zubehör
Battery
Lithium Ion Rechargeable Battery Pack.
To charge battery pack before first use, begin by
disconnecting the pack from the light head and attaching
the USB charging lead. Next, plug this lead into a suitable
USB power source. Princeton Tec suggests a charger with
minimum output of 5V, 1A. This charger will fully charge the
battery pack in 3 to 4 hours. Faster charging will be
achieved when a charger rated for higher amperage is
used. Under normal usage, the supplied lithium ion battery
pack will last for at least 1,000 charge / discharge cycles.
General care and warnings
• Disconnect battery pack during long periods of storage.
• Properly charge the battery to maximize its lifespan.
Lithium ion batteries do not suffer from a “memory effect,”
and for battery longevity it is preferable to charge more
frequently if possible, rather than to fully deplete the
battery’s charge.
• To avoid damaging your lighting system, use only
chargers that meet the approved specifications.
• Although APEX Rechargeable is designed for use in wet
weather conditions, it is not submersible. Submerging it in
water will damage the system and void the warranty.
• To keep your lighting system looking new, use a mild
soap and water solution with a rag or sponge to periodically
wipe off dirt.
• Never submerge the light, battery pack or cables in water.
Princeton Tec cares about the environment and
recommends recycling batteries. For more information
about battery recycling, please go to: www.batteryrecy-
cling.com.
Battery Power Meter
Multicolored LED
With the battery pack plugged into the APEX, the BPM
(battery power meter) will indicate charge status.
*Capacity percentage is the minimum expected remaining
power needed to operate the Maxbright LED in high mode
at 0° C. The purpose of the battery power meter is to give
you a general idea of the remaining burn time. Switching
modes can create an abrupt change in battery voltage
which may cause the indicator to change color. Once the
color turns yellow, the burn time remaining depends on the
typical discharge curve for the type of batteries you are
using. After the light has been turned off, the battery voltage
might temporarily increase, causing the battery power
meter to temporarily display an artificially higher setting.
When the light is off, the battery power meter will continue
to blink for 24 hours to indicate the current status of the
batteries. After 24 hours with no activity, the battery power
meter will turn off to conserve battery power. When the light
is turned on again, it will resume functioning.
Low Battery Signaling During Use
In addition to displaying red on the battery power meter,
when there are approximately 20 minutes of run time
remaining, the Apex will blink three times in rapid
succession. You can then decide to stay at your current
light level or switch to a lower light level, which may cause
battery voltage to rise enough that the battery power meter
transitions back to yellow. When the battery power meter
returns to red, the light will blink again to alert you.
Circuitry
The Apex uses a sophisticated circuit to control the light.
Under normal circumstances, the metal heatsink will
sufficiently cool the electronics and protect the LEDs from
damage. Should the internal temperature of the light get too
hot, a backup temperature protection circuit will activate
and gradually decrease the light output until the
temperature is within the specified limits. The Apex will
automatically turn off after 12 hours of inactivity. Any button
press during the 12 hour period will reset the auto off timer.
Never attempt to disassemble the lamp housing. It is sealed
to protect the components from water and there are no
user serviceable parts inside. Disassembly will void your
warranty! To keep the heatsink at peak performance, keep
the heatsink and plastic cover free of obstructions (mud
and dirt). Do not remove the heatsink cover—it is there to
protect you from the high temperature of the heatsink
during operation. If the heatsink cover is damaged or
broken under normal use, do not use the headlamp. See
the warranty and return policy for more information.
Power Consumption
The Apex uses a current-controlled circuit that maintains
constant light output as long as the batteries have sufficient
voltage. Constant burn time is dependent on battery
condition, LEDs, and light level selected. The Ultrabright
LEDs provide the maximum level of wide-angle flood light
for task work and the Maxbright provides a tightly focused
spotlight for distance illumination.
Troubleshooting
If the Apex fails to light:
• Check the batteries for proper connection.
• Inspect the cable for damage.
If the Apex does not seem to change brightness levels:
• The battery voltage may be too low to switch to a brighter
setting. This condiditon is normal for a regulated
LED/current-controlled circuit. You are most likely to
experience this issue in the Maxbright LED mode. Recharge
your battery pack to restore performance.
• In extreme heat conditions the internal temperature of
the light may be too hot and the LED temperature
protection circuit may have activated. Allow the light to
cool and try again.
Lifetime Warranty
Due to international regulations, Princeton Tec’s lifetime
warranty can only be offered to customers in the USA.
Princeton Tec offers a 10 year warranty to our customers
outside the USA. FULL WARRANTY – Princeton Tec
warrants this product to be free from defects in
workmanship and materials under normal use for as long
as you own this product. This warranty covers all of the
component parts of the product except batteries. This
warranty does not cover deterioration due to normal wear
or damage due to misuse, alteration, negligence,
accidents, or unauthorized repair. Princeton Tec will repair
or replace parts which are defective in workmanship or
materials. Your authorized Princeton Tec Dealer and
Princeton Tec are the only facilities authorized to repair the
product. After (3) unsuccessful attempts to repair the
product, you have the right to elect replacement of the
product or a refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR CONSE-
QUENTIAL DAMAGES ARE INCLUDED IN THIS
WARRANTY. (Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.) This
warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Princeton Tec reserves the right to change product
specifications without notice.
Return Policy
If your light fails to operate, follow these
simple steps:
1) Check batteries. Replace if necessary.
2) To send your light in for repair or replace-
ment, first contact Princeton Tec customer
service on to request an RMA 1-800-257-9080
number. Please have your light model, date of
purchase and a brief description of the fault
you are experiencing. No warranty repairs will
be accepted without an RMA number.
3) Return the light without batteries to:
Princeton Tec, PO Box 8057 Trenton NJ 08650
Postage due and freight collect items will not be
accepted.
4) Upon receipt your light will be processed in
about two weeks. Please allow additional time
for return transportation from New Jersey
OFF = press & hold
(1-2 seconds)
press 1x = High
press 2x = Low
ss 1x = High
ss 2x = Low
ss 3x = Flash
4 Ultrabright
LEDs
Maxbright
LED
Maxbright
LED
Spotlight
Ultrabright
LEDs
Operation / Fonctionnement / Betrieb
time is the total time that the headlamp produces a minimum of 0.25 lux at 2 meters.
0.25 lux is about the equivalent of a full moon on a clear night. Regulated burn time is
less than overall burn time.
Lithium Ion Rechargeable Battery
DISTANCE (Meters)
26 43 12067
Regulated
5H
HIGH
Regulated
8H
LOW
DISTANCE (Meters)
4326 12067
Regulated
20H
HIGH
Regulated
90H
LOW
Total
61H
FLASH
pr
es
pr
es
pr
es
4
Wide Beam
Bur
n t
Headlamp
Frontale Led
Stirnlampe
Extension Cable
Câble d’extension
Verlängerungskabel
USB Charging Cable
Câble de recharge USB
USB-Ladekabel
Battery Pack
Batterie
Akku-Einheit
Helmet Mounting Strap
Sangle pour montage sur casque
Helmbefestigungsriemen
Bike Helmet Mounted
Montage sur casque de vélo
Helmbefestigung
Produktspecifikationer
| Varumärke: | Princeton Tec |
| Kategori: | Ficklampa |
| Modell: | Apex |
Behöver du hjälp?
Om du behöver hjälp med Princeton Tec Apex ställ en fråga nedan och andra användare kommer att svara dig
Ficklampa Princeton Tec Manualer
26 Februari 2025
26 Februari 2025
26 Februari 2025
17 December 2024
23 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
Ficklampa Manualer
- Alpen Optics
- Asaklitt
- CAT
- Nedis
- Craftsman
- Carson
- Nordride
- Hama
- Streamlight
- IVT
- EMOS
- Underwater Kinetics
- KSE-Lights
- Gorenje
- VDO
Nyaste Ficklampa Manualer
12 Oktober 2025
12 Oktober 2025
9 Oktober 2025
9 Oktober 2025
9 Oktober 2025
8 Oktober 2025
8 Oktober 2025
8 Oktober 2025
8 Oktober 2025
7 Oktober 2025