Privileg PWHPD M11 82 N Bruksanvisning
Privileg
Torktumlare
PWHPD M11 82 N
Läs gratis den bruksanvisning för Privileg PWHPD M11 82 N (8 sidor) i kategorin Torktumlare. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 13 recensioner. Har du en fråga om Privileg PWHPD M11 82 N eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
THANK YOU FOR BUYING OUR PRODUCT.
EN
PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO REACH MORE INFORMATION.
Quick guide
Before using the appliance carefully
read the Safety Instruction.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the fi rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying
cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions
on clothing labels and the max loads indicated in the
programme section. Empty pockets. Make sure garments do not
get caught between the door and/or the door filter. Do not load
items that are dripping wet. Do not tumble dry large, very bulky
items. For optimal drying result, garments should be loaded one
by one.
3. Close the door.
4. Press the "On/Off" button.
5. Select the most suitable programme
for the type of fabric in
that load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator
on the control panel signals the end of the cycle. Turn the
machine off by pressing the "On/Off" button, open the door and
pull the clothing immediately out to prevent the formation of
creases on laundry.
If the machine is not switched off manually, after about a quarter
of an hour from the end of the cycle , the appliance turns off
automatically to save energy.
Note that some programme/option accords with "Crease Care"
system. This means that for some hours, after the end of the
drying cycle, the drum rotates at regular intervals to prevent the
formation of creases.
Note that some models perform a final cool tumble phase, for this
reason the fabrics may not feel hot.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle.
PUSH & GO
This function serves to start a cycle, after machine switching on,
without enabling any further button an/or knob (the programme
PUSH & GO will be deactivated instead).
It is always necessary to follow the points 1, 2, and 3 concerning
the daily use.
To start the cycle PUSH & GO, keep the button pressed. The light on
signals that the cycle is started. The cycle is suitable for cotton and
synthetic textiles. Max. load 4 kg. (Cycle duration 120’)
If the door is opened during the cycle, to restart it, close the door and
press the button START/PAUSE. This programme does not allow to
set other options.
Opening the door during the cycle
The tumble dryer door can be opened at any time during the cycle
to check progress and remove any garments already dry.
However, since opening the door can extend the drying time, the
recommendation is to keep the door closed throughout the cycle
process to save time and energy.
After closing the door, press the "Start/Pause" button within 15
minutes to resume the machine operation.
FIRST TIME USE
Make sure that the water tank is correctly inserted. Make sure
that the drain hose on the back of the dryer is properly fixed,
either to the dryers's water tank or to the domestic sewage
system.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before you use your dryer ensure that it has been in a upright
position for at least 6 hours.
CONTROL PANEL
1 ON/OFF button (hold for Reset)
2 Programme selection knob
3 Start/Pause
4 Push & Go
Options buttons*
5
Dryness level
6 Start delay
7 Timed drying
8 Cycle end
9 Light drying (hold for Key Lock)
10 Crease care ( hold for Mute)
*Note: some models may have the wording in full instead of the icons.
INDICATORS
Dryness level: Iron dry - Hanger dry - Cupboard dry -
+
+
+
+
Extra dry
Cycle phase:
END Dry - Cool tumble - End of cycle
Empty water tank - Clean door lter - Clean bottom lter
Refer to Troubleshooting section:
Failure call After-sales Service
1
3
2
4
10
8
9
5 6 7
DEMO
3’’
3’’
Produktspecifikationer
| Varumärke: | Privileg |
| Kategori: | Torktumlare |
| Modell: | PWHPD M11 82 N |
Behöver du hjälp?
Om du behöver hjälp med Privileg PWHPD M11 82 N ställ en fråga nedan och andra användare kommer att svara dig
Torktumlare Privileg Manualer
14 Januari 2025
2 September 2024
2 September 2024
2 September 2024
31 Augusti 2024
31 Augusti 2024
29 Augusti 2024
26 Augusti 2024
Torktumlare Manualer
- Nordland
- Schulthess
- White Knight
- Kelvinator
- Kluge
- Insignia
- Klarstein
- MO-EL
- SEIKI
- Infiniton
- Ghibli & Wirbel
- Frigidaire
- Sôlt
- Bush
- Asko
Nyaste Torktumlare Manualer
23 Oktober 2025
23 Oktober 2025
21 Oktober 2025
21 Oktober 2025
20 Oktober 2025
20 Oktober 2025
19 Oktober 2025
18 Oktober 2025
17 Oktober 2025
17 Oktober 2025