Projecta BLT100 Bruksanvisning

Projecta Batteriladdare BLT100

Läs gratis den bruksanvisning för Projecta BLT100 (4 sidor) i kategorin Batteriladdare. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 3.5 stjärnor baserat på 3 recensioner. Har du en fråga om Projecta BLT100 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/4

6 & 12V BATTERY

100 AMPS

LOAD TESTER

P/No. BLT100

CAUTION- BATTERIES PRODUCE EXPLOSIVE GASES,

TO REDUCE THE RISK OF EXPLOSION OR INJURY

ALWAYS ENSURE:

• No sparks or ames are present

• Eye protection is worn

• All vehicle or battery manufacturers instructions are followed

• Beware of moving parts

NOTE

The LOAD switch must not be pressed for longer than 10 seconds at a time, or

the product may be damaged.

When operating the unit for the rst time it is normal for a small amount of smoke

to develop as the lubricants used in the manufacturing process burn off.

Specications

Battery Load Test: 6 & 12V Lead Acid Batteries

Load: 100Amp @ 12V

50Amp @ 6V

Maximum Load ‘ON’ Time: 10 Seconds

Recommended Cool Down Time: 2 Minutes

Capacity Range: 200-1000CCA

Voltage Measured: 0-16V

Operating Instructions

Battery Load Test

1. Connect the RED clamp to the Positive (+) battery terminal or post.

2. Connect the BLACK clamp to the Negative (-) battery terminal or post.

If testing a battery in the vehicle, ensure the engine and all loads are’OFF’.

3. Note the batteries open circuit Voltage (OCV).

4. Press the ‘LOAD’ switch for 10 Seconds. Before releasing the ‘LOAD’

switch read the meter to determine the battery’s condition or approximate

capacity (For 12V batteries 200-1000CCA) & note the battery’s Voltage

while under load (Load Volts).

Charging System Test (12 Volt Vehicles)

1. Connect the RED clamp to the Positive (+) battery terminal or post.

2. Connect the BLACK clamp to the Negative (-) battery terminal or post.

Ensure the load tester and cables are clear of any moving parts.

3. Start the vehicle’s engine and operate at a fast idle speed, keep all accessorises,

lights & heater fan ‘OFF’.

4. Note the battery voltage, which should be in the green section of the charging

test, between 13.6 - 15 Volts, this indicates that the alternator’s regulator is

functioning correctly.

5. Turn ‘ON’ the vehicle’s head lights, heater fan or any other accessories,

the battery voltage should remain higher than 13.6 Volts, indicating that

the alternator is generating sufcient current.

Produktspecifikationer

Varumärke:	Projecta
Kategori:	Batteriladdare
Modell:	BLT100
Vikt:	1620 g
Bredd:	68 mm
Djup:	220 mm
Höjd:	38.8 mm
Internationell säkerhetskod (IP):	IP20
Hållbarhetscertifikat:	RoHS
Uteffekt:	185 W
Spännande:	42 V
AC-ingångsspänning:	90 - 264 V