QSC CX108V Bruksanvisning
Sidor 3 Engels mottagare
Läs bruksanvisningen för QSC CX108V gratis online eller ladda ner PDF:en. 20 personer har tyckt att guiden var hjälpsam. Fråga om modellen? Ställ en fråga
Current draw—120 VACPage 1 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω8Ω 4Ω 2Ω8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
ModelAmperesAmperes Amperes AmperesAmperesAmperes AmperesAmperesAmperesAmperes Amperes AmperesAmperes
CX302 0.93.55.4 8.6na5.1 8.712.9na8.413.922.2na
CX502 0.95.18.011.9na7.612.118.2na12.6 21.2 32.2na
CX702 0.85.07.711.5 na8.313.219.8 na15.926.741.1 na
CX902 0.95.99.213.2na10.5 16.8 24.6na20.4 34.3 52.3na
CX1102 0.97.611.6 16.6na13.1 20.3 30.4na25.1 40.6 58.6na
CX302V 1.0nr nr nr5.6nr nr nr8.0nr nr nr12.0
CX602V 0.98.7nr nr8.713.0nr nr13.020.5nr nr20.5
CX1202V 1.07.711.9nr 11.912.519.2nr 19.225.238.7nr 38.7
CX254 0.75.89.214.3na8.814.2 21.7na14.8 24.0 38.2na
CX404 0.78.112.4nr na12.219.3nr na21.733.4nr na
CX204V 0.8nr nr nr8.3nr nr nr12.7nr nr nr20.1
CX168 0.66.4 10.0nrna9.9 15.1nrna16.526.0nrna
CX108V 0.6nr nr nr6.4nr nr nr10.2nrnr nr15.6
CX Series Amplifier Current Draw—120 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 120 VAC usage; for 230- and 100-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
Where an asterisk (*) appears, the data was not available at press time. The designations "na" and
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
1/8 Power
1/3 Power
Full Power
Load per channel ->
Produktspecifikationer
| Varumärke: | QSC |
| Kategori: | mottagare |
| Modell: | CX108V |
Behöver du hjälp?
Om du behöver hjälp med QSC CX108V ställ en fråga nedan och andra användare kommer att svara dig
mottagare QSC Manualer
QSC SPA4-100 Bruksanvisning QSC ISA500Ti Bruksanvisning QSC CXD4.5 Bruksanvisning QSC MP-A40V Bruksanvisning QSC PLD4.5 Bruksanvisning QSC GX5 Bruksanvisning QSC SPA2-200 Bruksanvisning QSC RMX 2450a Bruksanvisning
Populära i mottagare
mottagare Manualer
Nyaste mottagare Manualer
Hifonics BRUTUS BG-1400.1 Bruksanvisning Hifonics BRUTUS BG-560.2 Bruksanvisning Hifonics BRUTUS BRL3000.1 Bruksanvisning MB Quart PA1-800.4 Bruksanvisning ESX FORCE R2/325 Bruksanvisning Ground Zero Competition GZCA 32000.M1 Bruksanvisning Dynacord U120:1M Bruksanvisning Hifonics Zeus Power ZXR400/2 Bruksanvisning Hifonics Zeus Evolution ZXE1000/5 Bruksanvisning Dynacord SR20TGX Bruksanvisning