QSC CX302V Bruksanvisning

QSC mottagare CX302V

Läs gratis den bruksanvisning för QSC CX302V (3 sidor) i kategorin mottagare. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 3 recensioner. Har du en fråga om QSC CX302V eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/3
Current draw—120 VAC Page 1 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 0.9 3.5 5.4 8.6 na 5.1 8.7 12.9 na 8.4 13.9 22.2 na
CX502 0.9 5.1 8.0 11.9 na 7.6 12.1 18.2 na 12.6 21.2 32.2 na
CX702 0.8 5.0 7.7 11.5 na 8.3 13.2 19.8 na 15.9 26.7 41.1 na
CX902 0.9 5.9 9.2 13.2 na 10.5 16.8 24.6 na 20.4 34.3 52.3 na
CX1102 0.9 7.6 11.6 16.6 na 13.1 20.3 30.4 na 25.1 40.6 58.6 na
CX302V 1.0 nr nr nr 5.6 nr nr nr 8.0 nr nr nr 12.0
CX602V 0.9 8.7 nr nr 8.7 13.0 nr nr 13.0 20.5 nr nr 20.5
CX1202V 1.0 7.7 11.9 nr 11.9 12.5 19.2 nr 19.2 25.2 38.7 nr 38.7
CX254 0.7 5.8 9.2 14.3 na 8.8 14.2 21.7 na 14.8 24.0 38.2 na
CX404 0.7 8.1 12.4 nr na 12.2 19.3 nr na 21.7 33.4 nr na
CX204V 0.8 nr nr nr 8.3 nr nr nr 12.7 nr nr nr 20.1
CX168 0.6 6.4 10.0 nr na 9.9 15.1 nr na 16.5 26.0 nr na
CX108V 0.6 nr nr nr 6.4 nr nr nr 10.2 nr nr nr 15.6
CX Series Amplifier Current Draw—120 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 120 VAC usage; for 230- and 100-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
1/8 Power
1/3 Power
Full Power
Load per channel ->
Current draw—230 VAC Page 2 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 0.5 1.8 2.7 4.3 na 2.6 4.4 6.5 na 4.2 7.0 11.1 na
CX502 0.5 2.6 4.0 6.0 na 3.8 6.1 9.1 na 6.3 10.6 16.1 na
CX702 0.4 2.5 3.9 5.8 na 4.2 6.6 9.9 na 8.0 13.4 20.6 na
CX902 0.5 3.0 4.6 6.6 na 5.3 8.4 12.3 na 10.2 17.2 26.2 na
CX1102 0.5 3.8 5.8 8.3 na 6.6 10.2 15.2 na 12.6 20.3 29.3 na
CX302V 0.5 nr nr nr 2.8 nr nr nr 4.0 nr nr nr 6.0
CX602V 0.5 4.4 nr nr 4.4 6.5 nr nr 6.5 10.3 nr nr 10.3
CX1202V 0.5 3.9 6.0 nr 6.0 6.3 9.6 nr 9.6 12.6 19.4 nr 19.4
CX254 0.4 2.9 4.6 7.2 na 4.4 7.1 10.9 na 7.4 12.0 19.1 na
CX404 0.4 4.1 6.2 nr na 6.1 9.7 nr na 10.9 16.7 nr na
CX204V 0.4 nr nr nr 4.2 nr nr nr 6.4 nr nr nr 10.1
CX168 0.3 3.2 5.0 nr na 5.0 7.6 nr na 8.3 13.0 nr na
CX108V 0.3 nr nr nr 3.2 nr nr nr 5.1 nr nr nr 7.8
Load per channel ->
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 230 VAC usage; for 120- and 100-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
CX Series Amplifier Current Draw—230 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
1/8 Power
1/3 Power
Full Power
Current draw—100 VAC Page 3 of 3
February 2016
Idle
Current
draw at
idle or
with very
low signal
level.
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω 8Ω 4Ω 2Ω25V-70V-100V 25V-70V-100V 25V-70V-100V
Model Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes Amperes
CX302 1.1 4.2 6.5 10.3 na 6.1 10.4 15.5 na 10.1 16.7 26.6 na
CX502 1.1 6.1 9.6 14.3 na 9.1 14.5 21.8 na 15.1 25.4 38.6 na
CX702 1.0 6.0 9.2 13.8 na 10.0 15.8 23.8 na 19.1 32.0 49.3 na
CX902 1.1 7.1 11.0 15.8 na 12.6 20.2 29.5 na 24.5 41.2 62.8 na
CX1102 1.1 9.1 13.9 19.9 na 15.7 24.4 36.5 na 30.1 48.7 70.3 na
CX302V 1.2 nr nr nr 6.7 nr nr nr 9.6 nr nr nr 14.4
CX602V 1.1 10.4 nr nr 10.4 15.6 nr nr 15.6 24.6 nr nr 24.6
CX1202V 1.2 9.2 14.3 nr 14.3 15.0 23.0 nr 23.0 30.2 46.4 nr 46.4
CX254 0.8 7.0 11.0 17.2 na 10.6 17.0 26.0 na 17.8 28.8 45.8 na
CX404 0.8 9.7 14.9 nr na 14.6 23.2 nr na 26.0 40.1 nr na
CX204V 1.0 nr nr nr 10.0 nr nr nr 15.2 nr nr nr 24.1
CX168 0.7 7.7 12.0 nr na 11.9 18.1 nr na 19.8 31.2 nr na
CX108V 0.7 nr nr nr 7.7 nr nr nr 12.2 nr nr nr 18.7
Load per channel ->
"Current draw" is the amount of AC current an amplifier demands while it is operating.
Measurements are provided for various loads at idle, 1/8 of average full power, 1/3 of average full
power, and full power, with all channels driven simultaneously. The figures shown on this sheet are
for 100 VAC usage; for 230- and 120-volt operation, see the companion sheets. For typical usage,
use the idle and 1/8 power figures.
"nr" respectively mean "not applicable" to the particular amplifier model and "not rated" for the
particular load impedance. Bridged mono into 8 ohms is equivalent to 4 ohms per channel; into 4
ohms is equivalent to 2 ohms per channel.
CX Series Amplifier Current Draw—100 VAC
Current draw at 1/8 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with light clipping
and repesents the amplifier's typical "clean"
maximum level, without audible clipping. Use
these figures for typical maximum level
operation.
Current draw at 1/3 of full power is measured
with pink noise as a signal. It approximates
operating with music or voice with very heavy
clipping and a very compressed dynamic range.
Current draw at full power is measured with a 1
kHz sine wave. However, it does not represent
any real-world operating condition.
1/8 Power
1/3 Power
Full Power

Produktspecifikationer

Varumärke: QSC
Kategori: mottagare
Modell: CX302V

Behöver du hjälp?

Om du behöver hjälp med QSC CX302V ställ en fråga nedan och andra användare kommer att svara dig