Salton BS20 Bruksanvisning
Salton
Vakuumpackare
BS20
Läs gratis den bruksanvisning för Salton BS20 (6 sidor) i kategorin Vakuumpackare. Guiden har ansetts hjälpsam av 26 personer och har ett genomsnittsbetyg på 3.8 stjärnor baserat på 13.5 recensioner. Har du en fråga om Salton BS20 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/6
VACUUM BAG
SEALER
Model: BS-20
POSITION ONLY
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should
always be followed including the following:
1. Read all instructions.
2. Do not touch hot surfaces. Use handles or knobs.
3. To protect against electrical hazards, do not immerse cord, plugs, or the
appliance in water or other liquid.
4.
Close supervision is necessary when any appliance is used by or near children.
5. Unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or plug or after the
appliance malfunctions, or has been damaged in any manner. Return
appliance to Salton for examination, repair or adjustment. See Warranty.
7. The use of accessories or attachments not recommended by Salton may
cause hazards.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. Prior to connecting or disconnecting plug from wall outlet, turn any
control to "off".
12. This appliance is for Household Use Only. Do not use appliance for other
than its intended use.
13. Do not leave unit unattended while in use.
2
SAVE THESE INSTRUCTIONS
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other).
To reduce the risk of electric shock, this plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not modify the plug in any way.
DESCRIPTION OF PARTS
1. Cover
2. Sealing Wire
3. Suction Nozzle
4. Polyethylene Roll
(Polyethylene Film)
5. Indicator Light
HOW TO USE
Make the Bag
1. Place the unit on a flat, level surface and plug into a 120 volt outlet.
2. Lift the cover and place the Polyethylene Roll so that it unwinds from the
bottom of the Roll.
3. When starting a new Roll, pull the Polyethylene Film about
1
/
2
" (1.25 cm)
over the Sealing Wire and make sure that the Polyethylene Film lies
smoothly.
4. Close the Cover and make a seal on the Film by pressing down both
areas that are marked ‘sealing’ on the right and left hand corners of the
Cover. The Indicator Light will go on and remain on for 10 seconds.
DO NOT SEAL LONGER THAN 10 SECONDS. When the Indicator Light
goes out release pressure on Cover. NOTE: The sealing time can be
shortened by simply lifting the Cover.
5. Lift the Cover. Remove excess
1
/
2
" (1.25cm) of Polyethylene Film. Unroll
Polyethylene Film to the desired bag width and seal again.(Follow directions
in #4 above) This will simultaneously create the first seam for the next bag
and separate the current bag from the rest of the Roll.
NOTE: DO NOT MAKE THE BAG LONGER THAN 11" (27.5 cm)
AS YOU WILL NOT BE ABLE TO SEAL THE TOP OF THE BAG.
3
2
1
3
4
5
Produktspecifikationer
| Varumärke: | Salton |
| Kategori: | Vakuumpackare |
| Modell: | BS20 |
Behöver du hjälp?
Om du behöver hjälp med Salton BS20 ställ en fråga nedan och andra användare kommer att svara dig
Vakuumpackare Salton Manualer
1 Augusti 2024
Vakuumpackare Manualer
- Viking
- Nesco
- Sammic
- Haier
- Ziploc
- Anova
- Imetec
- Rommelsbacher
- Create
- Solis
- Steba
- Westinghouse
- Techwood
- Luvele
- Gorenje
Nyaste Vakuumpackare Manualer
8 April 2025
2 April 2025
22 Mars 2025
18 Februari 2025
18 Februari 2025
11 Februari 2025
6 Februari 2025
8 Januari 2025
7 Januari 2025
7 Januari 2025