Sani-Lav 524F Bruksanvisning
Läs gratis den bruksanvisning för Sani-Lav 524F (6 sidor) i kategorin Sjunka. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 9.5 recensioner. Har du en fråga om Sani-Lav 524F eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/6
F L O O R M O U N T S I N K 1
Operating Manual for Floor Mount Stainless Steel Sink
Models 524F and 524F-0.5
of Domestic and Foreign Parts
Columbia does not recommend use with harsh chemicals.
Product Compliance
NSF/ANSI 2 Food Equipment, NSF/ANSI 61, Section 9, ASME A112.18.1/CSA B125.1
2
F L O O R M O U N T S I N K
COLUMBIA SPECIFICATIONS
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
Installation Instructions
Step 1
1. 1. Attach upper and lower leg support brackets to legs with hardware (provided).
2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.
3. Place wash station sink at the desired location.
4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.
5. Drill holes as required for mounting hardware. Hardware not included.
Step 2
1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread
sealant instead of Teflon tape.
2. Install strainer assembly to the drain hole.
3. Connect hot and cold water supply lines (not included) to the back of faucets.
Step 3
1. Position wash station sinks to pre-drilled holes and secure sink to the floor.
2. Connect waste line or drain pipe to the strainer assembly. Not included.
3. Connect water supply lines (Hot and Cold) to the water source. Not included.
4. Remove aerator from the spout and flush the water system.
5. Replace aerator to the spout.
6. Check for leaks and tighten connections if necessary.
Step 4
1. Seal gap between bowl and leg assembly as shown in illustration B.
2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as
shown on illustration C.
Parts List
(1) Floor mount sink
(1) Leg assembly set
(6) Nuts, bolts and washers for leg assembly
(4) Washers and nuts for connection sink to leg assembly set
(1) 8” on center faucet
(1) Faucet mounting kit
(1) Strainer assembly with basket
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips from
the spout or from
under the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source off. See if
water still leaks from the spout. If
leaks continues repair hot side if
not repair cold side.
Recommend
installing hot
or cold faucet
repair kit.
Go to for more information on replacement parts and installation videos.columbiasinks.com
WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),
Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
NOTE: Lead content originates from Brass components in valves and faucets and is certied under
NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.
Notice for California Consumers
Tools Required
Tape measure
Adjustable wrench
Drill motor and drill bits
Pipe wrench
Level
Safety glasses
Screw drivers: phillips and standard
Pencil
Socket wrench
Illustration A
Illustration B
Illustration C
3
F L O O R M O U N T S I N K
COLUMBIA SPECIFICATIONS
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
Hole Configurations
9” (228.6mm)
Front Side
16.75”(424.4mm)
27” (685.8mm)
10.5” (266.7mm)
45º
23” (584.2mm)
11.5”
(292.1mm)
11.5”
(292.1mm)
20.5”
(520.7mm)
17”
(431.8mm)
1.5” (38mm)
2” (51mm)
Top
20” (508mm) 20.5” (520.7mm)
2” (51mm)
1.5” (38mm)
.875” (22mm)
dia. holes (2)
6” (152.4mm)
10.5”
(266.7mm)
1.5” (38mm)
7.5” (191mm)
7.5”
(190.5mm)
7.5”
(190.5mm)
8”
(203.2mm)
3.25” (88.55mm)
2” drain hole
.5” R
(12.7mm)
.5” R (12.7mm)
Back Splash
Supply Line Detail
1/2” Male NPT
Hot
from Wall
Cold
from Wall
Floor Mounting Detail
1.5” Leg
Thickness
.75” From
Edge of Leg
to First Hole
.5” dia. Floor
Mounting Holes
9” on Center
Produktspecifikationer
| Varumärke: | Sani-Lav |
| Kategori: | Sjunka |
| Modell: | 524F |
Behöver du hjälp?
Om du behöver hjälp med Sani-Lav 524F ställ en fråga nedan och andra användare kommer att svara dig
Sjunka Sani-Lav Manualer
3 Mars 2025
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
Sjunka Manualer
- Kernau
- Advance Tabco
- Laveo
- Artusi
- Franke
- Deante
- Hendi
- Shaws
- Fulgor Milano
- Kuchinox
- Tot Mate
- Leisure
- Gustavsberg
- Blaupunkt
- Roca
Nyaste Sjunka Manualer
9 April 2025
8 April 2025
8 April 2025
2 April 2025
31 Mars 2025
30 Mars 2025
26 Mars 2025
4 Mars 2025
28 Januari 2025
27 Januari 2025