Schatten Design Mini Pre 2 Bruksanvisning
Schatten Design
Inte kategoriserad
Mini Pre 2
Läs gratis den bruksanvisning för Schatten Design Mini Pre 2 (1 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 14 personer och har ett genomsnittsbetyg på 3.5 stjärnor baserat på 7.5 recensioner. Har du en fråga om Schatten Design Mini Pre 2 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/1
Mini-Pre Acoustic Preamp Instructions
Getting started
1) Remove the back cover and install a 9 volt alkaline or lithium battery (not
included).
2) Install the belt clip to the back cover of the preamp using the two supplied
screws. Reinstall back cover.
3) Use standard 1/4" shielded instrument cables.
4) The input accepts all piezo and magnetic pickups (passive or active). It is a
good idea to turn down your amp or mixer before you plug into the input of the
preamp.
5) Note that the battery within the preamp is turned on only when a plug is
inserted into the output jack.
The Input Gain Trim Pot
1) There is a small trim pot for adjusting the input gain of the preamp. It is
positioned between the input and output jacks on the circuit board (as shown in
the diagram to the right) and is accessible with the back cover removed.
2) From our facility, this trim pot is set to approximately 7 db of input gain, which
works properly in most applications.
3) If the signal coming from your pickup is very weak, you may wish to turn the
input trim pot clockwise, which will raise the overall level and reduce system noise
(hiss). If you hear distortion when you play (with a new battery), lower
the input trim until it goes away.
4) For the cleanest signal, set the volume control (output gain) as high
as possible without distorting the amp or PA.
Important: The trim pot may be adjusted using a very small jewellers
slotted screwdriver.
Output
Plug a standard instrument cable from the output to an amp or an
unbalanced microphone input on a PA.
Specifications
Input Impedance: 10MOhm
Output Impedance: Less than 3.5kOhm
Input gain: 0 to 20 db
Battery life: 9 volt alkaline - 1500 hours
Do Not Use Rechargeable Batteries.
Rev. 04-19-2012
Produktspecifikationer
| Varumärke: | Schatten Design |
| Kategori: | Inte kategoriserad |
| Modell: | Mini Pre 2 |
Behöver du hjälp?
Om du behöver hjälp med Schatten Design Mini Pre 2 ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Schatten Design Manualer
22 September 2024
Inte kategoriserad Manualer
- Orbegozo
- Joovy
- Winston
- Ciarra
- Smoby
- Gamesir
- Lantronix
- GRAUGEAR
- EXO
- AOpen
- Faytech
- Smart
- Sikkens
- Avid
- Xaoc
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025