Sekonda 2136 Bruksanvisning

Sekonda klocka 2136

Läs gratis den bruksanvisning för Sekonda 2136 (2 sidor) i kategorin klocka. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 2 recensioner. Har du en fråga om Sekonda 2136 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/2

1. SLIDING CLASP

Insert

fine

tipped

tool

into

hole

clasp.

2. ADJUSTABLE CLASP

To set the bracelet to the required length, depress the end pin of the spring bar as indicated

below using a pointed instrument (e.g. a pin) and relocate the spring bar in any

one of the holes.

SPRING BAR

3. LINK ADJUSTMENT

Should you feel that your bracelet is too long or too short, the following procedure should

be adopted.

i) Complete your name and address and send with your watch direct by

registered post to Service Department, T.P. (UK) Ltd, Alexander House, Chartwell Drive,

Wigston, Leicester LE18 2EZ where it will receive immediate attention.

Do not send the presentation box as this will not be returned.

ii) Alternatively, if purchased from a High Street Jewellers shop, return this gauge with your watch

to that retailer.

FIRST ESTABLISH IF BRACELET IS 1, 2 OR 3 BELOW AND THEN PROCEED AS INDICATED

iv) When in selected position,

locate tabs on back of clasp

into slots on bracelet and snap

down/close the clip

[see procedure (ii)].

IMPORTANT

To avoid straining the clip do

not use excessive pressure.

If resistance is found when

closing clip, the tabs are not lo-

cated properly and should

be re-located.

ii) To open/

close clasp

clip, move

the tool in

the direction

indicated.

iii) Slide clasp along

bracelet to

desired

position.

IF THE LENGTH

REQUIRES FURTHER

ADJUSTMENT

INSTRUCTION 3.

OPEN CLOSE

Customer’s name: ........................................................

Address: .........................................................................

..........................................................................................

..............................................

Postcode:........................

Daytime Phone No:......................................................

GS01/09.10

120mm 130mm 140mm 150mm 160mm 170mm 180mm 190mm 200mm 210mm 220mm 230mm

BRACELET

GAUGE

1. Place gauge round wrist.

2. Adjust to comfortable length on wrist.

3. Mark tape at required length.

DO NOT ATTEMPT ADJUSTING BRACELET YOURSELF.

GS01

Produktspecifikationer

Varumärke:	Sekonda
Kategori:	klocka
Modell:	2136
Typ av klocka:	Armbandsur
Kronograf:	Nej
Kronometer:	Nej
Vattentät:	Nej
Urtavlans huvudfärg:	Guld
Produktdesign:	Lyx
Typ av urtavla:	Analog urtavla
Mekanism typ:	Kvarts
Höljefärg:	Blue, Gold
Armbandets huvudfärg:	Blå
Utformning:	Rund
Typ av markeringar:	Utan siffror
Stöttålig:	Nej
Färg på urtavlans markeringar:	Guld
Könstyp:	Honkoppling