Speco Technologies O2VB1N Bruksanvisning
Läs gratis den bruksanvisning för Speco Technologies O2VB1N (42 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 19 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 10 recensioner. Har du en fråga om Speco Technologies O2VB1N eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/42
User Manual
2MP IP Camera
O2VB1/O2V V/O2VT1/O2V V B1 T1
Please read this instrucon carefully before operang the unit keep it for further reference and
Important Safeguards and Warnings
1. Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in device damage!
The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2. Environment
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quantity of
neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth)
may result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an opcal device, please don t touch or wipe cover surface directly during installaon and use, please refer to ’
the following methods if dirt is found.
Stained with dirt:
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free cotton cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth
and wipe several mes if it is not clean enough.
Warning
This camera should be installed by qualied personnel only.
All the examinaon and repair work should be done by qualied personnel.
Any unauthorized changes or modicaons could void the warranty.
Statement
This guide is for reference only.
Product, manuals and specicaons may be modied without prior noce. Speco Technologies reserves the right to modify
these without noce and without incurring any obligaon.
Speco Technologies is not liable for any loss caused by improper operaon.
Regulatory Informaon
FCC condions:
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operaon.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protecon against harmful interference. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instrucon manual, may cause
harmful interference to radio communicaon. However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Note:
Before installaon, check the package and make sure that all components are included.
Contact your rep or Speco customer service department immediately if something is broken or missing in the package.
Accessory name
Amount
Network Camera Unit
1
Juncon Box
1
Quick Start Guide
1
Installaon Accessories Bag
1
CD
1
Produktspecifikationer
| Varumärke: | Speco Technologies |
| Kategori: | övervakningskamera |
| Modell: | O2VB1N |
Behöver du hjälp?
Om du behöver hjälp med Speco Technologies O2VB1N ställ en fråga nedan och andra användare kommer att svara dig
övervakningskamera Speco Technologies Manualer
8 Januari 2025
8 Januari 2025
27 Oktober 2024
27 Oktober 2024
23 September 2024
9 September 2024
7 September 2024
7 September 2024
6 September 2024
6 September 2024
övervakningskamera Manualer
- Mobi
- Canon
- Astak
- Flir
- Kramer
- Swann
- Hombli
- QSC
- Rostra
- I-PRO
- Summer Infant
- Sir Gawain
- Cisco
- Olympia
- Rollei
Nyaste övervakningskamera Manualer
15 Juni 2025
14 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025