Speco Technologies O4D6M Bruksanvisning
Läs gratis den bruksanvisning för Speco Technologies O4D6M (35 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 3 recensioner. Har du en fråga om Speco Technologies O4D6M eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/35

User Manual
4MP / 8MP(4K) Camera IP
O4VLB5/O4VLD5/O4B6M/O4D6M
O4DT5/O4DT6M/O4MD3/O4T8
O8B6M/O8D6M
Please read this manual carefully before operang the unit and keep it for further reference

IP Camera User Manual
Important Safeguards and Warnings
1 Electrical safety
.
.
.
..
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in device damage! The
product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
.
.
.
..
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quanty of neutral
detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may result
in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an optical device, please don’t touch or wipe cover surface directly during installation and use, please refer to the
following methods if dirt is found:
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth and wipe
several mes if it is not clean enough.

IP Camera User Manual
Warning
This camera should be installed by qualied personnel only.
All the examinaon and repair work should be done by qualied personnel.
Any unauthorized changes or modicaons could void the warranty.
Statement
This guide is for reference only.
Product, manuals and specicaons may be modied without prior noce. Speco Technologies reserves the right to modify these
without noce and without incurring any obligaon.
Speco Technologies is not liable for any loss caused by improper operaon.
Regulatory Informaon
1.1 FCC conditions
:
:
:
::
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions:
This device may not cause harmful interference
This device must accept any interference received, including interference that may cause undesired operaon.
1.2 FCC compliance
:
:
:
::
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protecon against harmful interference. This equipment generate, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instrucon manual, may cause harmful interference to
radio communicaon. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment
does cause harmful interference to radio or television recepon, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Note:
Before installaon, check the package and make sure that all components are included.
Contact your rep or Speco customer service department immediately if something is broken or missing in the package.
Accessory Name
Amount
Network Camera Unit
1
Quick Start Guide
1
Installaon Accessories Bag
1
CD
1
Produktspecifikationer
Varumärke: | Speco Technologies |
Kategori: | övervakningskamera |
Modell: | O4D6M |
Behöver du hjälp?
Om du behöver hjälp med Speco Technologies O4D6M ställ en fråga nedan och andra användare kommer att svara dig
övervakningskamera Speco Technologies Manualer
8 Januari 2025
8 Januari 2025
27 Oktober 2024
27 Oktober 2024
23 September 2024
9 September 2024
7 September 2024
7 September 2024
6 September 2024
6 September 2024
övervakningskamera Manualer
- Jung
- Megasat
- Compro
- Xavax
- Yale
- Woonveilig
- Y-cam
- DataVideo
- Netgear
- Trust
- Switel
- Vimtag
- Atlona
- Iiquu
- Chacon
Nyaste övervakningskamera Manualer
15 Juni 2025
14 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025