Speco Technologies O4DT1 Bruksanvisning
Läs gratis den bruksanvisning för Speco Technologies O4DT1 (11 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 5.5 recensioner. Har du en fråga om Speco Technologies O4DT1 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/11
Quick Start Guide
4MP Turret IP Camera
O4DT1
Version 1.0.0
i
Welcome
Thank you for purchasing this network camera!
This manual is designed to be a reference guide for the product .
Please read this manual carefully before operang the unit and retain it for future reference.
Should you require any technical assistance, please contact Speco Technologies Technical Support.
ii
Important Safeguards and Warnings
1 Electrical safety
．
．
．
．．
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class 2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may
result in device damage! The product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2 Environment
．
．
．
．．
Heavy stress, violent vibraon or exposure to water is not allowed during transportaon, storage
and installaon.
This product should be installed in a cool, dry place away from direct sunlight and heat sources.
Do not install the product in extreme temperature condions.
Do not expose the camera to electromagnec radiaon. Otherwise it may result in CMOS sensor
failure.
Do not block any venlaon openings.
Do not allow water and liquid intrusion into the camera.
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance
work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the
lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened
with a small quanty of neutral detergent. Finally use the dry cloth to clean the device.
Please use a professional opcal cleaning method to clean the enclosure. Improper enclosure
cleaning (such as using cloth) may result in poor IR funconality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the
reliability of the camera.
Dome cover is an opcal device, please don’t touch or wipe cover surface directly during
installaon and use, please refer to the following methods if dirt is found:
Stained with dirt
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center
outward. Change the cloth and wipe several mes if it is not clean enough.
Produktspecifikationer
| Varumärke: | Speco Technologies |
| Kategori: | övervakningskamera |
| Modell: | O4DT1 |
Behöver du hjälp?
Om du behöver hjälp med Speco Technologies O4DT1 ställ en fråga nedan och andra användare kommer att svara dig
övervakningskamera Speco Technologies Manualer
8 Januari 2025
8 Januari 2025
27 Oktober 2024
27 Oktober 2024
23 September 2024
9 September 2024
7 September 2024
7 September 2024
6 September 2024
6 September 2024
övervakningskamera Manualer
- Vimtag
- Waeco
- Niceboy
- Blink
- Kerbl
- Valueline
- Sanyo
- Mobi
- Sir Gawain
- Qolsys
- Setti+
- Defender
- Allnet
- KlikaanKlikuit
- Comtrend
Nyaste övervakningskamera Manualer
15 Juni 2025
14 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025