Supermicro SuperServer 1018L-MP Bruksanvisning
Supermicro
Inte kategoriserad
SuperServer 1018L-MP
Läs gratis den bruksanvisning för Supermicro SuperServer 1018L-MP (1 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 3.8 stjärnor baserat på 10.5 recensioner. Har du en fråga om Supermicro SuperServer 1018L-MP eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/1

http://www.supermicro.com MNL-1604-QRG
Board Layout
SuperServer 1018L-MP Quick Reference Guide
Power Button
2 x USB Ports
Audio Port
Description
No.
Drive bay Installation/RemovalMEMORY
Caution
1
2
3
SAFETY INFORMATION
IMPORTANT: See installation instructions and safety warning
before connecting system to power supply.
http://www.supermicro.com/about/policies/safety_information.cfm
WARNING:
To reduce risk of electric shock/damage to equipment,
disconnect power from server by disconnecting all power
cords from electrical outlets.
If any CPU socket empty, install protective plastic CPU cap
CAUTION:
Always be sure all power supplies for this system have
the same power output. If mixed power supplies are
installed, the system will not operate.
For more information go to :
http://www.supermicro.com/support
!
!
!
Position the SO-DIMM mod -1.
ule's bottom key so that it
aligns with the receptive point
on the slot . Take note of the
Module’s side notches
and the locking clips on the socket
Insert the SO-DIMM module 2.
staight down.
Press down until the module 3.
locks into place. The side clips
will automatically secure the
SO DIMM module, locking it
into place .
To 4. Remove: Use your thumbs
to gently push the side clips
near both ends away from the
module. This should release
it from the slot. Pull the SO
DIMM module upwards .
Installling 2.5" S A AT Drives
1. Power down the system and unplug the AC/DC Power Adapter.
2. Remove the chassis cover.
3. Use screws to secure the drive into the hard drive bracket.
4. Use screws to secure the bracket/drive assembly into the middle holding bar
of the chassis as shown in the figure.
Beep Codes
1 beep - circuits have been reset (ready to power up).
5 short beeps + 1 long beep - No memory detected
in the system
1 continuous beep with front panel Overheat LED on -
system overheat
5 short beeps - display memory error
When a recoverable type of error occurs during
POST, BIOS will display a POST code that
describes the problem. BIOS may also issue one
of the following beep codes:
Front View & Interface
In ion LEformat al D
S us t ntat Descrip io
Blue Power On
Blinking White HDD Activity
123
Descrip iot n
No.
PCI-E 2.0 p1-x16
Mini PCI-E scoket
JSD1 = SATA Disk on Module (DOM) Power
CPU socket
DIMMA1 Memory Slot
DIMMB1 Memory Slot
JTPM = TPM (Trusted Platform Management) Header
I-SATA2/3: SATA 2.0 ports (3Gb/s)
I-SATA0/1: SATA 3.0 ports (6Gb/s)
JBT1: CMOS Clear
1
2
3
4
5
6
7
8
9
10
5
6
1
I-SATA3
I-SATA2
JGPIO1
JPW2
JP1
JPCIE1
JSMB1
JBT1
BT1
COM4
COM
JAUDIO1
FAN2
FAN1
CA
JTPM1
JVR1
JL
JSD1
JD1
I-SATA0
I-SATA1
SP1
+
DIMMA1
DIMMB1
PW1
CMOS CLEAR
PCIE
mini
JUSB2LAN2
JUSBLAN1
4
2
3
10
7
8
9
A nlig
ÌMNL-1604-QRGcÎ
Produktspecifikationer
Varumärke: | Supermicro |
Kategori: | Inte kategoriserad |
Modell: | SuperServer 1018L-MP |
Strömförsörjning: | 80 W |
Processorfamilj: | Intel |
Hörlursutgångar: | 1 |
Maximalt internminne: | 16 GB |
Minnesspänning: | 1.5 V |
Kompatibla processorer: | Intel Celeron, Intel Pentium |
Antal processorer som stöds: | 1 |
Antal lagringsenheter som stöds: | 1 |
Minnestyper som stöds: | DDR3-SDRAM |
BIOS-typ: | EEPROM |
ACPI-version: | 2.0 |
Produktens färg: | Svart |
Typ av ethernet-gränssnitt: | Fast Ethernet, Gigabit Ethernet |
Datahastighet för Ethernet-LAN: | 10,100,1000 Mbit/s |
Antal LAN (RJ-45) anslutningar: | 2 |
Temperatur vid drift: | 0 - 40 ° C |
Temperaturintervall (förvaring): | -20 - 60 ° C |
Intervall för relativ operativ luftfuktighet: | 10 - 85 % |
Fuktighet (förvaring): | 10 - 95 % |
processorsockel: | LGA 1150 (uttag H3) |
Seriella portar: | 2 |
Fläktdiameter: | 60 mm |
BIOS-funktioner: | Plug & Play |
Antal USB 2.0 anslutningar: | 4 |
Icke ECC: | Ja |
Antal USB 3.2 Gen 1 (3.1 Gen 1) typ A-portar: | 2 |
BIOS minnesstorlek: | 128 mbit |
LAN-styrenhet: | Intel I210-AT, Intel I217 |
Antal fläktar: | 1 fläkt/-ar |
Ombord grafikkort modell: | Intel® HD Graphics 4600 |
Uttag för mikrofon/linje in: | Ja |
Storlekar som stöds på lagringsenhet: | 2.5 " |
Koppar Ethernet-kablar teknik: | 1000BASE-T, 100BASE-TX, 10BASE-T |
Lagringsenhetsgränssnitt som stöds: | Serial ATA II, Serial ATA III |
Antal SATA III kontakter: | 2 |
Antalet DIMM-platser: | 2 |
Som stöds DIMM-modul kapacitet: | 1GB, 2GB, 4GB, 8GB |
Antal SATA II kontakter: | 2 |
Minnets formfaktor: | 204-pin SO-DIMM |
Behöver du hjälp?
Om du behöver hjälp med Supermicro SuperServer 1018L-MP ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Supermicro Manualer
1 April 2025
1 April 2025
31 Januari 2025
31 Januari 2025
31 Januari 2025
31 Januari 2025
9 Januari 2025
4 Januari 2025
29 December 2024
29 December 2024
Inte kategoriserad Manualer
- Verizon
- Manta
- Sennheiser
- Trace Elliot
- Kuppersbusch
- Sony
- Comfee
- Vorago
- Rowenta
- LawnMaster
- Taqua
- Kaiser Nienhaus
- Proline
- ESUN
- Fredenstein
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025