Swann SWVID-PENBL4 Bruksanvisning
Swann
övervakningskamera
SWVID-PENBL4
Läs gratis den bruksanvisning för Swann SWVID-PENBL4 (8 sidor) i kategorin övervakningskamera. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 6 recensioner. Har du en fråga om Swann SWVID-PENBL4 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/8
2
IMPORTANT NOTE: Prohibition against eavesdropping
All jurisdictions have specic laws and regulations relating to the use of cameras.
Before using any camera for any purpose, it is the buyer’s responsibility to be aware
of all applicable laws and regulations that prohibit or limit the use of cameras and to
comply with the applicable laws and regulations.
Warnings:
• Modications not approved by the party responsible for compliance could void
user’s authority to operate the equipment.
• PenCam recorder
• Operating Instructions
• Ink Rell
Before You Begin
Package Contents
Layout of the Pencam
Blue / Orange
Status LED
Reset Button
Hidden
Camera
Hidden USB Port
(Twist to reveal)
Working
Pen Tip Power/Record
button
USB Connection
The USB port and mode
selection switch are concealed
inside the PenCam.
To access them, you need to
hold one end of the pen and
twist the other end counter-
clockwise until the two parts
separate.
Mode
Select Switch
3
Picture
mode
Video
mode
Turning the PenCam On
• Press the power/record button (on top o the pen) and hold until the both the
orange and blue lights turn on then release it. When the camera is ready to use
the orange standby light will stay on and the blue light will turn o.
• The orange light will blink when it is on standby in picture mode or stay lit when
it is on standby in video mode.
Turning the PenCam O
• Leave the Pencam in standby mode and it will automatically turn o after 60
seconds of inactivity
• The PenCam will not switch o while it is actually recording.
• If the PenCam is recording you must press the button once to stop recording and
return to standby (static orange light) then leave the camera for 60 seconds until
the orange light turns o indicating that the Pencam has turned o automatically.
Operating the Pencam
Switching between Video and Picture
To switch between Video and Picture mode,
unscrew the PenCam to reveal the USB
connector. Using the tip of a pen or ngernail,
move the selection switch (pictured) to the
right for PICTURE or left for VIDEO.
Charging the PenCam
The PenCam has a built in lithium-ion battery that provides approximately 45
minutes of power when fully charged.
Charge the PenCam by connecting the hidden USB connector inside the PenCam to
a USB port on your computer. The status LED will slowly ash orange while charging.
Full charge time is approximately 90 minutes. The PenCam will stop ashing when it
is fully charged.
IMPORTANT NOTE: Before using the PenCam for the rst time, connect it to a USB
port and charge it fully. The PenCam will not function as a camera while it is plugged
into the USB port.
Produktspecifikationer
| Varumärke: | Swann |
| Kategori: | övervakningskamera |
| Modell: | SWVID-PENBL4 |
Behöver du hjälp?
Om du behöver hjälp med Swann SWVID-PENBL4 ställ en fråga nedan och andra användare kommer att svara dig
övervakningskamera Swann Manualer
13 Juni 2025
12 Juni 2025
3 Oktober 2024
16 September 2024
16 September 2024
15 September 2024
9 September 2024
9 September 2024
9 September 2024
8 September 2024
övervakningskamera Manualer
- DataVideo
- Vimtag
- Aritech
- Videotec
- Inovonics
- Setti+
- Hama
- VisorTech
- Owltron
- Trendnet
- Linear PRO Access
- Genius
- Crestron
- Asus
Nyaste övervakningskamera Manualer
15 Juni 2025
14 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
13 Juni 2025
12 Juni 2025
2 Juni 2025