Techno Line WS 9116 Bruksanvisning
Läs bruksanvisningen för Techno Line WS 9116 gratis online eller ladda ner PDF:en. Bruksanvisningen har visats 5 gånger. Fråga om modellen? Ställ en fråga
INTRODUCTION WS 9116
FEATURES:
• Four digit time display
• 12-hour or 24-hour selectable time
• Indoor temperature (°C or °F)
• Outdoor temperature (°C or °F)
• Minimum and Maximum temperature
• Four level RF strength indicator
• Wall hanging or free standing
• Low battery indicator for receiver and transmitter
SET UP:
NOTE: This temperature station can receive one transmitter only.
• First, insert batteries into the transmitter, observing the correct polarity (see
marking inside battery compartment). Keep transmitter 5-10 feet from the
temperature station.
• Within 30 seconds of powering up the transmitter, insert batteries into the
Temperature Station, observing the correct polarity (see marking inside battery
compartment). Once the batteries are in place, all segments of the LCD will
light up briey.
Following the indoor temperature will be displayed. If the indoor temperature is
not shown in the LCD after 60 seconds, remove the batteries and wait for at
least 60 seconds before reinserting them. Once the indoor data is displayed
you may proceed to the next step.
• After the batteries are inserted, the Temperature Station will start receiving
outdoor temp data from the transmitter. The outdoor temperature should then
be displayed on the Temperature station. If this does not happen after 2
minutes, remove the batteries from both units and start again from the
beginning.
• In order to ensure sucient 433 MHz transmission, the outdoor transmitter
should be placed a distance of no more than 100 feet (30 meters) from the
Temperature Station and the transmitter.
TEMPERATURE SELECTION:
FAHRENHEIT/CELSIUS: Press the CF/SET button once to switch from
Celsius to Fahrenheit.
FOUR LEVEL RF INDICATOR: The temperature station will indicate strength
of signal reception from the outdoor transmitter by the number of bars on the
RF indicator icon.
4-bars: Shows after initial set up and stays when reception is at full strength.
3-bars: Indicates one reception failure from the outdoor transmitter.
2-bars: Indicates two reception failures from the outdoor transmitter.
1-bar: Indicates three reception failures from the outdoor transmitter.
Produktspecifikationer
| Varumärke: | Techno Line |
| Kategori: | |
| Modell: | WS 9116 |
Behöver du hjälp?
Om du behöver hjälp med Techno Line WS 9116 ställ en fråga nedan och andra användare kommer att svara dig