TK Audio M/S Station Bruksanvisning
TK Audio
Inte kategoriserad
M/S Station
Läs gratis den bruksanvisning för TK Audio M/S Station (5 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 24 personer och har ett genomsnittsbetyg på 5.0 stjärnor baserat på 12.5 recensioner. Har du en fråga om TK Audio M/S Station eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/5
M/S Staon
Advanced M/S tool
www.tkaudio.se
The M/S Staon is a new mastering and main bus tool with four separate funcons divided into two sec-
ons including an advanced cue funcon.
Secon 1 is a parallel insert with M/S funcon allowing the user to use separate blend controls for the mid
and side signals. For maximum precision the blend control(s) has 16 posions from dry to wet.
Secon 2 consists of three parts, an ellipcal EQ with 16 frequencies, a width control from 0-200% and an
advanced cue funcon.
The two secons are normally linked internally but can be used separately with their own balanced inputs
and outputs by removing four jumpers inside the unit (see unlink secon 1 and 2). This way you can use
them at dierent locaons in your setup.
Parallel insert with M/S funcon:
With the insert secon you can insert an external
processor like an EQ, compressor, distoron unit
etc, and then dial in a mix between the processed
signal (wet) and the unprocessed signal (dry).
For maximum precision the blend control has 16
steps from dry to wet.
If you acvate the M/S funcon your signal will
be coded into mid ( L+R ) and side ( L-R ). The mid
signal normally contains all the center info such
as bass, kick drum, lead vocal etc and the side
signal contains all the panned parts of the signal.
In M/S you can process the mid signal and side
signal separately with dierent types of proces-
sors and the blend controls is placed infront of
the M/S encoder before it’ decoded back to le
and right signals.
With the blend split funcon you get separate
blend controls for the mid and side signal.
Ellipcal Equalizer:
With the ellipcal EQ all frequencies below a
selected frequency will be made to mono. This
funcon can make your low end more focused.
It’s an old technique used when mastering for
vinyl.
Too much low end in the side channel (vercal)
can make the needle bounce slightly and cause
distoron.
By using a 12dB high pass lter in the side chan-
nel you set the frequency under which the signal
will be processed as mono. As a HPF introduces
phase shi to the signal, a phase correcon
is added to the mid channel keeping channel
separaon as good as possible. The EEQ has 16
frequencies from 36Hz to 302Hz.
With the EEQ cue funcon you can monitor the
signals that are mixed between the channels.
Produktspecifikationer
| Varumärke: | TK Audio |
| Kategori: | Inte kategoriserad |
| Modell: | M/S Station |
Behöver du hjälp?
Om du behöver hjälp med TK Audio M/S Station ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad TK Audio Manualer
3 Mars 2025
25 September 2024
23 September 2024
22 September 2024
17 September 2024
17 September 2024
16 September 2024
9 September 2024
Inte kategoriserad Manualer
- EarthQuaker Devices
- Nilox
- Buzz Rack
- Blukac
- MyPhone
- Majority
- Best Service
- Fisher Paykel
- Lamax
- KNEKT
- Ultimate
- KS Tools
- StarTech.com
- Tece
- Schoeps
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025