Uniden DCX 640 Bruksanvisning

Uniden Telefon DCX 640

Läs gratis den bruksanvisning för Uniden DCX 640 (8 sidor) i kategorin Telefon. Guiden har ansetts hjälpsam av 5 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 3 recensioner. Har du en fråga om Uniden DCX 640 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/8
2
Welcome
Congratulations on your purchase of the Uniden DCX640 optional
handset and charger. This additional handset is for use with the DCT64
2.4GHz Digital Spread Spectrum series (DCT646, DCT648, DCT6465,
DCT6485), model numbers may vary. Each model within this series will
support up to 4 handsets. You can place a fully featured cordless
handset anywhere in your home as long as you have AC power is
available to connect the handset charging cradle.
IMPORTANT
The DCX640 additional handset will not operate unless it has been
registered to the main base unit of the cordless model you are
expanding. This manual describes only the instructions specific to the
additional handset. For detailed operation, refer to the owner’s manual
supplied with the cordless telephone you are expanding (see
“Expanding Your Phone”).
To purchase additional handsets (DCX640), visit our web site at
www.uniden.com.
Checking the Package Contents
Make sure you have received the following items in the package.
If any of these items are missing or damaged, contact the Uniden
Parts Department.
Cordless Handset
Charging Cradle
Battery Pack (BT-446)
(Capacity: 800 mAH, 3.6V)
AC Adapter (AD-310)
(INPUT: 120V AC 60Hz) (OUTPUT: 9V DC 210 mA)
• Beltclip
This Owner’s Manual
Other Printed Material
Uniden Parts Department at (800) 554-3988
Hours: M-F 8:00 a.m. to 5:00 p.m. CST.
or visit our website at
www.uniden.com
3
Install the Rechargeable Battery
Pack into the Handset
Follow these steps before using your cordless handset:
Make sure the handset is registered to main base unit.
Fully charge the battery pack.
1Press down on the handset battery
case cover (use the finger indention
for a better grip) and slide the cover
downward to remove.
2Plug the battery pack connector (red
& black wires) into the jack inside the
battery compartment. (The connector
notches fit into the grooves of the
jack only one-way.) Match the wire
colors to the polarity label in the
battery compartment, and push the
connector in until you hear a click.
3Make sure you have a good connection
by slightly pulling on the battery wires.
If the connection is secure, the battery
jack will remain in place.
4Place the battery case cover back on
the handset by sliding it upwards
until it clicks into place.
5Place the handset in the charging
cradle with the keypad facing forward.
Use only the Uniden battery (BT-446)
supplied with your phone.
Replacement batteries are also available
through the Uniden Parts Department.
(See page 2.)
Recharge your handset on a regular
basis by returning the handset to the
charger after each phone call.
Rechargeable Nickel-Metal-Hydride Batteries
Must Be Recycled or Disposed of Properly

Produktspecifikationer

Varumärke: Uniden
Kategori: Telefon
Modell: DCX 640

Behöver du hjälp?

Om du behöver hjälp med Uniden DCX 640 ställ en fråga nedan och andra användare kommer att svara dig