Vicoustic VicStudio Bruksanvisning
Vicoustic
ej kategoriserat
VicStudio
Läs gratis den bruksanvisning för Vicoustic VicStudio (19 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 1.5 recensioner. Har du en fråga om Vicoustic VicStudio eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/19
EN
VicStudio VMT Box
Installation Manual
EN
2
Not Included
MATERIAL NEEDED
Included
Wall Plugs and ScrewsDrillLevel
Measuring Tape
6mm Phillips Screwdriver Caulking Gun
Silicone Drop x8 VicFix Corner 2 +2
FlatPanel VMT x6 VicPET x12VicSpacer x6
Glue x1
Multifuser DC3 x4
VicFix J Prole 80mm | 3.14" x4
VicFix Mini x8 Gauge x1
EN
3
Multifuser DC3 Installation
2
Place the panel on the suitably chose
position on the wall. Once in the desired
place, press rmly against the wall for 15
seconds.
1
Apply three lines of glue on the back of the
acoustic panel. Do not wait longer than 10
minutes after applying the glue to attach the
panel to the wall.
Wall and ceilling surfaces should be examined prior to installation, ensuring they are clean, smooth, and dry. If you have
unpainted gypsum board surfaces, these should be primed with a drywall primer (or another material manufactured especially
for the purpose), to equalize the absorption between the gypsum board face paper, joint compound, and skin coating materials.
You should then apply the paint, and allow air circulation in order to dry the paint within the time frame specied by the paint
manufacturer. Please ensure the paint is dry before installing the acoustic panel. Make sure the room has all the necessary
conditions to receive the acoustic panels. After you apply the glue on the back of each acoustic panel, please ensure you hold
the acoustic panel against the wall the required time (mentioned above), and ensure it stays xed in place. This method is also
applicable to ceiling installations.
!
To ensure that you maximise the strength of the glue, don’t make any adjustments
to the panel after bonding
50mm
Cut the tip of the glue nozzle according to the diagram.
You can also install de Multifuser DC3 with the supplied VicFix Mini. Please consult the
Multifuser DC3 installation manual, available on vicoustic.com
i
Produktspecifikationer
| Varumärke: | Vicoustic |
| Kategori: | ej kategoriserat |
| Modell: | VicStudio |
Behöver du hjälp?
Om du behöver hjälp med Vicoustic VicStudio ställ en fråga nedan och andra användare kommer att svara dig
ej kategoriserat Vicoustic Manualer
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
ej kategoriserat Manualer
- Vishay
- Crown
- IFM
- Saris
- Drayton
- Mercusys
- T-Spec
- Dedra
- Gys
- Spelsberg
- Evenflo
- Strymon
- TAMA
- Thermaltake
- Fischer
Nyaste ej kategoriserat Manualer
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025
7 Augusti 2025