Victron Energy Skylla IP44 Bruksanvisning
Victron Energy
Batteriladdare
Skylla IP44
Läs gratis den bruksanvisning för Victron Energy Skylla IP44 (2 sidor) i kategorin Batteriladdare. Guiden har ansetts hjälpsam av 10 personer och har ett genomsnittsbetyg på 4.7 stjärnor baserat på 5.5 recensioner. Har du en fråga om Victron Energy Skylla IP44 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
www.victronenergy.com
Skylla
Skylla
Skylla
SkyllaSkylla-
-
-
--
I
I
I
IIP44
P44
P44
P44P44 (1+1): two out
(1+1): two out
(1+1): two out
(1+1): two out(1+1): two outputs to charge 2
puts to charge 2
puts to charge 2
puts to charge 2puts to charge 2 battery banks
battery banks
battery banks
battery banks battery banks
The Skylla-IP44 (1+1) features 2 isolated outputs. The second output, limited to approximately 3A and with
a slightly lower output voltage, is intended to top up a starter battery.
Skylla
Skylla
Skylla
SkyllaSkylla-
-
-
--
I
I
I
IIP44
P44
P44
P44P44 (3): three f
(3): three f
(3): three f
(3): three f(3): three full current outputs t
ull current outputs t
ull current outputs t
ull current outputs tull current outputs to charge 3 bat
o charge 3 bat
o charge 3 bat
o charge 3 bato charge 3 battery banks
tery banks
tery banks
tery bankstery banks
The Skylla-IP44 (3) features 3 isolated outputs. All outputs can supply the full rated output current.
IP44
IP44
IP44
IP44IP44
protection
protection
protection
protectionprotection
Steel epoxy powder coated case and splash proof. Withstands the rigors of an adverse environment: heat,
humidity and salt air.
Circuit boards are protected with an acrylic coating for maximum corrosion resistance.
Temperature sensors ensure that power components will always operate within specified limits, if needed
by automatic reduction of output current under extreme environmental conditions.
LCD
LCD
LCD
LCDLCD ispl
ispl
ispl
isplisplay
ay
ay
ayay
d
d
d
d d
For status monitoring and to easily adapt the charge algorithm to a particular battery and its conditions of
use.
CAN
CAN
CAN
CANCAN bus
bus
bus
busbus nterface
nterface
nterface
nterfacenterface NMEA2000)
NMEA2000)
NMEA2000)
NMEA2000)NMEA2000)
i
i
i
i i (
(
(
( (
To connect to a CAN bus network, to a Skylla to the Color Control digital disp-i Control panel or lay.
Synchr
Synchr
Synchr
SynchrSynchroni
oni
oni
onionise
se
se
sese pa
pa
pa
paparalle
ralle
ralle
ralleralle
d
d
d
d d l op
l op
l op
l opl opera
era
era
eraeratio
tio
tio
tiotion
n
n
nn
Several chargers can be connected in parallel and synchronised with help of . This is the CAN bus interface
achieved by simply interconnecting the chargers with RJ45 UTP- cables.
Th
Th
Th
ThTh ight
ight
ight
ightight mount
mount
mount
mountmount harg
harg
harg
hargharg r
r
r
rr ead
ead
ead
eadead
e r
e r
e r
e re r a
a
a
a a o
o
o
o of c
f c
f c
f cf c e fo
e fo
e fo
e foe fo a l
a l
a l
a l a l -
-
-
--acid battery: va
acid battery: va
acid battery: va
acid battery: vaacid battery: variable absorpti
riable absorpti
riable absorpti
riable absorptiriable absorption time
on time
on time
on timeon time
When only shallow discharges occur the absorption time is kept short in order to prevent overcharging of
the battery. After a deep discharge the absorption time is automatically increased to make sure that the
battery is completely recharged.
Preventin
Preventin
Preventin
PreventinPreventing
g
g
gg ama
ama
ama
amaamag
g
g
gg du
du
du
dudu o
o
o
oo ces
ces
ces
cescessiv
siv
siv
sivsiv assing:
assing:
assing:
assing:assing: h
h
h
hh atter
atter
atter
atteratterySa
ySa
ySa
ySaySa od
od
od
odode
e
e
ee
d
d
d
d d e
e
e
e e e t
e t
e t
e te t ex
ex
ex
ex ex e g
e g
e g
e ge g t
t
t
t t e B
e B
e B
e Be B fe m
fe m
fe m
fe mfe m
If, in order to quickly charge a battery, a high charge current in combination with a high absorption voltage
has been chosen, the Skylla-IP44 will prevent damage due to excessive gassing by automatically limiting
the rate of voltage increase once the gassing voltage has been reached.
Less mainte
Less mainte
Less mainte
Less mainteLess maintenance and aging when
nance and aging when
nance and aging when
nance and aging whennance and aging when the battery is
the battery is
the battery is
the battery is the battery is not in use: the St
not in use: the St
not in use: the St
not in use: the St not in use: the Storage
orage
orage
orageorage mode
mode
mode
mode mode
The Storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In
the storage mode float voltage is reduced to 2,2V/cell (26,4V for 24V battery) to minimise gassing and
corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘refresh’
the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early
battery failure.
To
To
To
ToTo ncr
ncr
ncr
ncrncreas
eas
eas
easeas att
att
att
attattery
ery
ery
eryery ife:
ife:
ife:
ife:ife: em
em
em
ememperatur
peratur
peratur
peraturperatur ompensat
ompensat
ompensat
ompensatompensation
ion
ion
ionion
i
i
i
i i e b
e b
e b
e be b l
l
l
l l t
t
t
t t e c
e c
e c
e ce c
Every Skylla comes with a battery temperature sensor. When connected, charge voltage will -IP44
automatically decrease with increasing battery temperature. This feature is especially recommended for
sealed lead-acid batteries and/or when important fluctuations of battery temperature are expected.
Battery voltage s
Battery voltage s
Battery voltage s
Battery voltage sBattery voltage sense
ense
ense
enseense
In order to compensate for voltage loss due to cable resistance, the Skylla is provided with a voltage - IP44
sense facility so that the battery always receives the correct charge voltage.
Use
Use
Use
UseUse ower
ower
ower
owerower pply
pply
pply
pplypply
as a p
as a p
as a p
as a p as a p su
su
su
su su
As a result of the can be used as a power supply excellent control circuit, the Skylla- IP44 with perfectly
stabilized output voltage if batteries or large buffer capacitors are not available.
Li
Li
Li
LiLi Io
Io
Io
IoIon
n
n
nn LiFePO4)
LiFePO4)
LiFePO4)
LiFePO4)LiFePO4) ead
ead
ead
eadeady
y
y
yy
-
-
-
-- (
(
(
( ( r
r
r
r r
Simple charger on-off control can be implemented by connecting a relay or open collector opto coupler
output from a Li Ion BMS to the remote control port of the charger. Alternatively complete control of -
voltage and current can be achieved by connecting to the CAN bus port.
Learn more about
Learn more about
Learn more about
Learn more about Learn more about batteries and
batteries and
batteries and
batteries and batteries and battery charging
battery charging
battery charging
battery chargingbattery charging
To learn more about batteries and charging batteries, please refer to our book ‘Energy Unlimited’ (available
free of charge from Victron Energy and downloadable from www.victronenergy.com).
Skylla- IP44 Battery Charger
Skylla
Skylla
Skylla
SkyllaSkylla-
-
-
-- )
)
)
))
IP
IP
IP
IPIP 12/
12/
12/
12/12/ 1+1
1+1
1+1
1+11+1
44
44
44
44 44 60 (
60 (
60 (
60 (60 (
12V/60A and 24V/30A, input voltage range 90 -265V
Skylla
Skylla
Skylla
SkyllaSkylla-
-
-
--
IP
IP
IP
IPIP 6
6
6
66 1+1)
1+1)
1+1)
1+1)1+1)
44 12/
44 12/
44 12/
44 12/44 12/ 0 (
0 (
0 (
0 (0 (
Produktspecifikationer
| Varumärke: | Victron Energy |
| Kategori: | Batteriladdare |
| Modell: | Skylla IP44 |
Behöver du hjälp?
Om du behöver hjälp med Victron Energy Skylla IP44 ställ en fråga nedan och andra användare kommer att svara dig
Batteriladdare Victron Energy Manualer
31 December 2025
2 September 2024
30 Augusti 2024
27 Augusti 2024
24 Augusti 2024
23 Augusti 2024
23 Augusti 2024
21 Augusti 2024
18 Augusti 2024
18 Augusti 2024
Batteriladdare Manualer
- DJI
- Studer
- Kenwood
- ICU
- EMOS
- Xvive
- Makita
- Parkside
- Logitech
- Banner
- Black Decker
- Waeco
- Bigben Interactive
- Powerbank
- Kaco
Nyaste Batteriladdare Manualer
15 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025
12 Oktober 2025
9 Oktober 2025
5 Oktober 2025
5 Oktober 2025
3 Oktober 2025