Vitek VT-2415A-A18 Bruksanvisning

Läs gratis den bruksanvisning för Vitek VT-2415A-A18 (1 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 25 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 6 recensioner. Har du en fråga om Vitek VT-2415A-A18 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

ACA) ) 24V (10A/15(9CHCH/18Power Supply Models ----VT2410AA9 & VT2415AA18!

Installation instruction:

1. Install box at desired location in a cool place. The power

supply can be wall . Make the hole position on mounted

the wall using the back of the box as a template and drill

four holes. Screw in the top two holes with the mounting

M4 screws hang the power supply box - tand hen affix

the bottom screws. Use drywall anchors if solid beams

are unavailable.

2. Knock out (remove) the appropriate forated knockouts per

for running cables through.

3. Turn power switch to “OFF” position.

4.U” Connect each camera device to one "+U” & one “-

power output terminal .

5.11 Plug the AC plug into local 0VAC power outlet. Turn

power switch to “ON” position. The green LED light

should be on showing power is being supplied to the

camera.

6.Clos e the cover and secure it with provided screw.

Technical Specifications

Each channel is protected with a 1.1 ~1.6Amp, PTC

resettable fuse.

Operation the temperature: - +86 degrees F 14 to

Storage temperature: - +140 degrees F 14 to

Notes:

1. When used in an extreme weather climate the power ,

panel may take up 30 seconds to boot up after initial

connection to power.

2.2 To avoid the risk of fire use only type STP-wire or

heavier 18AWG cooper . Use wire gauge No.at minimum

suitable for at least 194 degrees F.

!!!

!

Produktspecifikationer