Warmup Ultralight Bruksanvisning
Warmup
Inte kategoriserad
Ultralight
Läs gratis den bruksanvisning för Warmup Ultralight (6 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 15 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 8 recensioner. Har du en fråga om Warmup Ultralight eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/6

Installation manual
Warmup Ultralight 10YEAR
LIMITED
WARRANTY
W
A
R
M
U
P
1
0
Y
E
A
R
W
A
R
R
A
N
T
Y
W
A
R
M
U
P
1
0
Y
E
A
R
W
A
R
R
A
N
T
Y
4in1
Insulating
Heat Spreading
Decoupling
Sound Reducing

2
Installation
The suboor must be clean and dry and if necessary, smoothed
with a self-levelling compound to give an even surface.
NOTE: The maximum permissible departure from a 2 m straight
edge, resting under its own weight on the suboor is 3 mm. (SR1
Standard - BS 8204).
Prime suboors with a dilute (1:4) SBR solution. For proprietary
suboors refer to the manufacturer instructions.
Provided the suboor is adequately prepared and clean, it may
not be necessary to prime. This can vary depending tile adhesive
selection. Please refer to the tile adhesive manufacturers
instructions for priming information.
1
2

3
Installation
Ultralight should be installed using a exible, cement-based
adhesive. The adhesive should be trowelled out and combed
through using a 6 mm x 6 mm (¼” x ¼”) square notch trowel to give
a ribbed bed, any slight depressions in the suboor being lled by
the mortar.
NOTE: If you plan to apply a levelling compound over Ultralight
apply Warmup perimeter strip to the edge of the room to allow for
dierential movement between the nished oor level and walls.
Ultralight should be laid on the freshly applied ribbed bed and
thoroughly bedded in to ensure that no voids are left beneath the
boards and they are solidly supported. All boards should be laid
with staggered joints.
NOTE: Allow the adhesive attaching the boards to the suboor
to cure before laying electric underoor heating directly onto the
boards.
3
4
Produktspecifikationer
Varumärke: | Warmup |
Kategori: | Inte kategoriserad |
Modell: | Ultralight |
Behöver du hjälp?
Om du behöver hjälp med Warmup Ultralight ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Warmup Manualer
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
26 December 2024
Inte kategoriserad Manualer
- Think Tank
- Pabobo
- Laserworld
- Anex
- Slik
- Blow
- RAM Mounts
- Advantix
- Mr Gardener
- Benavent
- Sincreative
- Tzumi
- Bontempi
- Yeyian
- IDIS
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025