Wolf SRT486C Bruksanvisning
Läs gratis den bruksanvisning för Wolf SRT486C (25 sidor) i kategorin Ugn. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 3.5 recensioner. Har du en fråga om Wolf SRT486C eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/25
Sealed Burner Rangetop
Installation Guide
SPECIFI CATI ONS, IN STALLATIO N ,
AND MORE
2 | Wolf Customer Care 800.222.7820
Sealed Burner Rangetop
Contents
3 Specifications
6 Installation
7 Troubleshooting
Features and specifications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
Important Note
To ensure this product is installed and operated as safely
and eciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or prod-
uct damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
wolfappliance.com | 3
Rating plate location
RATING PLATE
Specifications
Planning Information
When installing against a combustible surface, a minimum
5" (127) riser is required for model SRT366, and a minimum
10" (254) riser is required for 36" and 48" sealed burner ran-
getops with a charbroiler or griddle. Follow all minimum
clearances to combustible surfaces shown in the illustra-
tion on page 5. Models SRT362W and SRT484W cannot be
installed against a combustible surface.
Electrical Requirements
Installation must comply with all applicable electrical codes.
Locate the electrical supply within the shaded area shown
in the illustration on page 5. A separate circuit servicing
only this appliance is required. A ground fault circuit inter-
rupter (GFCI) is not recommended and may cause inter-
ruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 110/120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 6' (1.8 m)
Product Information
Important product information, including the model and
serial number, are listed on the product rating plate. The
rating plate is located on the bottom of the control panel,
at the far right. Refer to the illustration below.
If service is necessary, contact Wolf Factory Certified
Service with the model and serial number. For the name of
the nearest Wolf Factory Certified Service or for questions
regarding the installation, visit the Product Support section
of our website, wolfappliance.com, or call Wolf Customer
Care at 800-222-7820.
Produktspecifikationer
| Varumärke: | Wolf |
| Kategori: | Ugn |
| Modell: | SRT486C |
Behöver du hjälp?
Om du behöver hjälp med Wolf SRT486C ställ en fråga nedan och andra användare kommer att svara dig
Ugn Wolf Manualer
2 April 2025
6 Februari 2025
27 December 2024
27 December 2024
27 December 2024
27 December 2024
27 December 2024
18 Oktober 2024
16 Oktober 2024
7 Oktober 2024
Ugn Manualer
- Dometic
- Vedette
- Kucht
- Axis
- Gude
- Delonghi
- Gorenje
- Aroma
- Sunbeam
- Ravanson
- Steelmatic
- Unold
- Sharp
- Creda
- Sauter
Nyaste Ugn Manualer
16 Juni 2025
16 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025