AMX VARIA-ACS-80F Bruksanvisning
Sidor 2 Engelska Inte kategoriserad
Läs bruksanvisningen för AMX VARIA-ACS-80F gratis online eller ladda ner PDF:en. Bruksanvisningen har visats 43 gånger. Fråga om modellen? Ställ en fråga
QUICK START GUIDE
VARIA-ACS-80F 8” Fixed Tabletop Stand
VARIA-ACS-100F
10.1” Fixed Tabletop Stand
Overview
TheVariaFixed Tabletop stands are designed for 8” VARIA-80 & 10.1” VARIA-100
Touch Panels, and give them a sturdy & stylish fixed-angle tabletop solution
that’s reminiscent of AMX’s Modero touch panel family.
FIG. 1VariaTouch Panel on Fixed Tabletop Stand
Model Availability & Compatibility
FIXED TABLETOP STANDS
VARIA-ACS-80F
(AMX-UMT0801)
VARIA-80 Touch Panel (AMX-UTP0811)
VARIA-ACS-100F
(AMX-UMT1001)
VARIA-100 Touch Panel (AMX-UTP1011)
VARIA-100N Touch Panel (AMX-UTP1011N)
Other Models Available
ANGLE-SELECT TABLETOP STANDS
VARIA-ACS-810A
(AMX-UMT8111)
VARIA-80 Touch Panel (AMX-UTP0811)
VARIA-100 Touch Panel (AMX-UTP1011)
VARIA-100N Touch Panel (AMX-UTP1011N)
VARIA-ACS-150A
(AMX-UMT1511)
VARIA-150 Touch Panel (AMX-UTP1511)
VARIA-150N Touch Panel (AMX-UTP1511N)
Installation
VariaFixed Tabletop Stands are easily installed with the supplied hardware and
a Philips-head screwdriver.
1.Place the panel face-down on a soft cloth, and orient the panel so
that the top of the touch panel is closest to you.
FIG. 2Varia Touch Panel, rear
2.If they are installed, remove two screws from the lower back cover.
Screw Locations
FIG. 3Rear cover screws, if installed
3.Place your thumbs onthe rectangular access holes, and push the
lower cover away from you.The lower cover can thenbe placed
aside; it is not used with the Fixed Tabletop Stands.
FIG. 4 Rear cover removal
4.Rotatethe panel back around so the bottom is closest to you.
5.On the tabletop stand, remove the black plastic cover by sliding it
away from the aluminum base. It is held on by magnets. Then
unscrew the rubber pads from the base.
6.Install the aluminum base on the back o the touch panel.
Note:In mostcircumstances, the networking cable can be routed in
after base installation. However, category cables with bulky strain
relief and/or hoods over the RJ-45 connector may need to be installed
before the aluminum base.
FIG.5Fixed Tabletop Stand, aluminum base, underneath
7.Attach the base with the four (4) supplied screws.
Top
Top
Produktspecifikationer
| Varumärke: | AMX |
| Kategori: | Inte kategoriserad |
| Modell: | VARIA-ACS-80F |
Behöver du hjälp?
Om du behöver hjälp med AMX VARIA-ACS-80F ställ en fråga nedan och andra användare kommer att svara dig