Azden SMX-10 Bruksanvisning

Azden mikrofon SMX-10

Läs gratis den bruksanvisning för Azden SMX-10 (2 sidor) i kategorin mikrofon. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 9.5 recensioner. Har du en fråga om Azden SMX-10 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
Thank you for purchasing the Azden SMX-10 stereo microphone. The SMX-10 is designed for videographers
that require high quality stereo sound pick-up.
BATTERY:
Unscrew the lower half of the microphone by turning the
case counter clockwise. Insert one AAA battery into the
case. Check for correct polarity. Replace the case and turn
clockwise to tighten. Do not over tighten or you may
damage the threads.
PLUG-IN POWER:
The SMX-10 may also operate on “plug-in power” if
provided by the connected camera’s microphone input. In
this case a battery is not required. However, for best
performance the use of a fresh battery is recommended.
MICROPHONE HOLDER:
Snap the microphone into the holder towards the back of the case. Slide the holder onto the
shoe mount of the camera and tighten the wheel until snug. Do not over tighten or you may
damage the threads.
WINDSCREEN:
Slide the windscreen over the front end of the microphone and cover all the vents on the
case.
OUTPUT CABLE:
Plug the microphones output cable into the “Ext. Mic” input jack on your camera.
POWER SWITCH:
Switch to “ON” for normal operation using battery power.
Switch to “OFF” to avoid draining the battery and/or to use plug-in power.
Note: The SMX-10 will continue to operate even when the power switch is turned off and/or a battery
is not installed if plug-in power is provided by the microphone input jack.
LOW CUT FILTER SWITCH:
: Turn the low cut filter switch to “ON” to reduce low frequency sounds and
increase clarity.
: Turn the low cut filter switch to “OFF” for flat response and maximum bass.
SMX-10 STEREO MICROPHONE INSTRUCTION MANUAL
0
90
2700.50.5
180
0.5
0.5
1kHz
R ch
0
90
2700.50.5
180
0.5
0.5
1kHz
L ch
SPECIFICATIONS
Type: Stereo Electret Condenser
Sensitivity: -40 dB (at 1 kHz 1 V/Pa)
Frequency Response: 100 – 20,000 Hz
Output Impedance: 1.5 kΩ (at 1 kHz)
Power Source: DC 1.5 V AAA size battery
Max. SPL: 100 dB
Signal Noise Ratio: More than 60 dB
Plug Cord Assembly: Coiled cord with φ 3.5 mm plug
POLAR PATTERN


Produktspecifikationer

Varumärke: Azden
Kategori: mikrofon
Modell: SMX-10

Behöver du hjälp?

Om du behöver hjälp med Azden SMX-10 ställ en fråga nedan och andra användare kommer att svara dig