Best EB15 Bruksanvisning
Best
ventilationskåpa
EB15
Läs gratis den bruksanvisning för Best EB15 (20 sidor) i kategorin ventilationskåpa. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 4.5 stjärnor baserat på 2 recensioner. Har du en fråga om Best EB15 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/20
BEST BY BROAN, P.O. BOX 140 HARTFORD, WI 53027
Model EB15
EXTERIOR MOUNTED
BLOWER
For use with compatible
Best by Broan range hoods.
See hood manual for suitability.
2
READ AND SAVE THESE INSTRUCTIONS
WARNING
Refrigeration and Air Conditioning En-
gineers (ASHRAE), and the local code
authorities.
5. When cutting or drilling into wall, or ceiling,
do not damage electrical wiring or other
hidden utilities.
6. Ducted fans must always be vented to the
outdoors.
7. To reduce risk of fire, use only metal
ductwork.
8. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not
use to exhaust hazardous or explosive
material and vapors.
2. To avoid motor bearing damage and noisy
and/or unbalanced impellers, keep drywall
spray, construction dust, etc. off power
unit.
3. Please read specification label on product
for further information and requirements.
4. Electrical circuit, including speed control,
(if used), must be rated 6 AMPS minimum.
WARNING
TO REDUCE THE RISK OF FIRE, ELEC-
TRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended
by the manufacturer. If you have ques-
tions, contact the manufacturer at the
address or telephone number listed in
the warranty.
2. Before servicing or cleaning unit, switch
power off at service panel and lock the
service disconnecting means to prevent
power from being switched on acciden-
tally. When the service disconnecting
means cannot be locked, securely fasten
a prominent warning device, such as a
tag, to the service panel.
3. Installation work and electrical wiring
must be done by a qualified person(s)
in accordance with all applicable codes
and standards, including fire-rated con-
struction codes and standards.
4. Sufficient air is needed for proper com-
bustion and exhausting of gases through
the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow
the heating equipment manufacturer’s
guideline and safety standards such
as those published by the National
Fire Protection Association (NFPA),
and the American Society for Heating,
INSTALLER: Leave This Manual With
The Homeowner.
HOMEOWNER: Use And Care Infor-
mation On Page 6.
SPECIFICATIONS
MODEL VOLTS AMPS CFM DUCT SIZE
EB15 120 4.3 1500 10 “ DIA.
1. Locate the blower so the length of the
duct run and number of elbows are kept
to a minimum.
2. Where possible, blower
should be centered be-
tween wall studs or roof
rafters.
3. Avoid pipes, wires, or
other ductwork that may
be running through the
wall.
4. Attach mounting plate to
top of hood.
5. Install 10” dia. ductwork
and 120 VAC house
wiring between blower
location and hood location.
ALL INSTALLATIONS
PLAN THE INSTALLATION
MODEL EB15
EXTERIOR BLOWER
ALL HOOD
CANOPY
10" ROUND
DUCT
SOFFIT
ROUGH-IN
PLATE
21" or 24"
10"
or
18"
MODEL
EB15
EXTERIOR
BLOWER
WALL HOOD
CANOPY
10" ROUND DUCT
SOFFIT
ROUGH-IN
PLATE
21" or 24"
10"
or
18"
10" ROUND ELBOW
TYPICAL
ROOF MOUNTED IN-
STALLATION
TYPICAL WALL
MOUNTED IN-
STALLATION
3
PREPARE THE
INSTALLATION LOCATION
ROOF INSTALLATIONS
WALL INSTALLATIONS
2”
29-1/2”
2”
25”
7”
PREPARE THE
INSTALLATION LOCATION
1. Locate the blower on the rear slope of
the roof. Place it in a location to minimize
duct run. The location should be free of
obstacles (T.V. leads, electrical lines,
etc.). If the blower top is level with the roof
peak, it will not be seen from the street.
Keep this approximate location in mind
as you work from within the attic.
2. Mark and drill a centered guide hole
between roof rafters.
11" dia.
hole
1"
Ø
20½"
Ø
18"
12
5
/
8
"
1¼" dia. hole
Roof Rafter
REMOVE SHINGLES
Roof Rafter
Guide hole
(centered
between rafters)
12
11
/
16
"
21"
3. From the outside, use the guide hole as
a starting point to lay out the installation:
A. Use a T-square to measure 12
5
/
8
” to the
left up of the guide hole, then 12
11
/
16
” to
locate the top-left corner of the layout.
B. Starting from the top-left corner, mark the
rectangular cutout (21” W x 20½” H) and
remove only the shingles in this area.
C. Mark an 11” diameter hole centered on
the guide hole. Cut this hole through the
roof board(s).
D. Mark and cut a 1¼” diameter hole
through the roof board(s) where shown.
4. For flat
r o o f
i n s t a l -
lations,
b u i l d
a cur b
that will
m o u n t
t h e
b l o w e r
at a min-
i m u m
pitch of 2/12. Discharge end of the
blower should be pointed downward.
1. Choose a position on the outside wall.
Make sure that no wall studs, pipes or
wires run through the opening area.
2. From inside, mark and drill a guide hole
centered between wall studs.
25"
29½"
14
11
/
16
"
14
5
/
8"
Wall Stud
Wall Stud
11" dia.
hole
20"
1¼" dia. hole
3
"
Ø
Ø
REMOVE
SIDING
Guide hole
(centered between studs)
3. From the outside, use the guide hole as
a starting point to lay out the installation:
A. Use a T-square to measure 14
5
/
8
” to
the left up of the guide hole, then
14
11
/
16
” to locate the top-left corner
of the layout.
B. Starting from the top-left corner,
mark the rectangular cutout (25”
W x 29½” H) and remove only the
siding in this area.
C. Mark an 11” diameter hole cen-
tered on the guide hole. Cut this
hole through the roof board(s).
D. Mark and cut a 1¼” diameter hole
through the roof board(s) where
shown.
Produktspecifikationer
| Varumärke: | Best |
| Kategori: | ventilationskåpa |
| Modell: | EB15 |
Behöver du hjälp?
Om du behöver hjälp med Best EB15 ställ en fråga nedan och andra användare kommer att svara dig
ventilationskåpa Best Manualer
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
ventilationskåpa Manualer
- ATAG
- Fagor
- Café
- Novy
- Hoover
- Miele
- Whirlpool
- Haier
- Omega
- Lamona
- Airlux
- Franke
- Candy
- Artusi
- Trade-Wind
Nyaste ventilationskåpa Manualer
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025
30 Augusti 2025