Celestron Neximage 10 Bruksanvisning

Celestron Kamera Neximage 10

Läs gratis den bruksanvisning för Celestron Neximage 10 (12 sidor) i kategorin Kamera. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 6 recensioner. Har du en fråga om Celestron Neximage 10 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/12
NexImage
USER’S MANUAL
Model #93708, #93711
#95518, #95519
ENGLISH
2 | ENGLISH
Congratulations on your purchase of the Celestron NexImage
Solar System imaging camera.
Your NexImage camera comes with the following:
+ NexImage Camera
+ 1.25” nose piece
+ CD including NexImage iCap and RegiStax processing software
+ USB Cable
Recommended Minimum System requirements:
+ Pentium IV, 2.0 GHz, 1GB RAM
+ Graphics card with 24 or 32 bit
+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)
+ DirectX 9.0c or higher
1.25”
Nose Piece
USB CableNexImage Camera NexImage iCap and
Registax processing
software
Fig 1
ENGLISH | 3
Quick Start
1. Place the CD into your computer’s
CD-ROM drive.
2. Install both the NexImage iCap and
RegiStax software onto your computer.
3. Thread the 1.25” nose piece into the body
of the NexImage camera. See Fig 2.
4. Slide the 1.25” nose piece of the camera
into the eyepiece barrel of your telescope.
See Fig 3.
5. Plug the small end of the USB cable into
the port on the back of the camera.
6. Plug the other end of the USB cable
into a USB port on your computer.
Once connected, the Found New
Hardware message will appear. Follow
the Installation Wizard until the device
has been successfully installed.
Fig 2
Fig 3

Produktspecifikationer

Varumärke: Celestron
Kategori: Kamera
Modell: Neximage 10
Färg på produkten: Beige
Bredd: 125 mm
Djup: 75 mm
Höjd: 38 mm
Tillgångar: 70 W
siffra: 1

Behöver du hjälp?

Om du behöver hjälp med Celestron Neximage 10 ställ en fråga nedan och andra användare kommer att svara dig