Celestron NexImage 5 Bruksanvisning

Celestron Kamera NexImage 5

Läs nedan 📖 manual på svenska för Celestron NexImage 5 (12 sidor) i kategorin Kamera. Denna guide var användbar för 2 personer och betygsatt med 4.6 stjärnor i genomsnitt av 1.5 användare

Sida 1/12
USERS MANUAL
Model #93711
English
Congratulations on your purchase of the Celestron NexImage 5 Solar System imaging camera.
Your NexImage camera comes with the following:
+ NexImage 5 Camera
+ 1.25” nose piece
+ CD including NexImage iCap and RegiStax processing software
+ USB Cable
Recommended Minimum System requirements:
+ Pentium IV, 2.0 GHz, 1GB RAM
+ Graphics card with 24 or 32 bit
+ Windows XP, Windows Vista, Windows 7 (32 & 64 bit)
+ DirectX 9.0c or higher
1.25”
Nose Piece USB CableNexImage 5 Camera
NexImage iCap and
Registax processing
software
Fig 1
1
Quick start
1. Place the CD into your computer’s CD rom drive.
2. Install both the NexImage iCap and RegiStax software
onto your computer.
3. Thread the 1.25” nose piece into the body of the
NexImage camera. see Fig 2.
4. Slide the 1.25” nose piece of the camera into the eyepiece barrel of your telescope. .see Fig 3
5. Plug the small end of the USB cable into the port on the back of the camera.
6. Plug camera into the USB port of your computer. Once connected, the Found New Hardware
message will appear. Follow the Installation Wizard until the device has been successfully installed.
2
Fig 2
Fig 3

Produktspecifikationer

Varumärke: Celestron
Kategori: Kamera
Modell: NexImage 5

Behöver du hjälp?

Om du behöver hjälp med Celestron NexImage 5 ställ en fråga nedan och andra användare kommer att svara dig