Cotech EMT448 Bruksanvisning

Cotech Inte kategoriserad EMT448

Läs gratis den bruksanvisning för Cotech EMT448 (5 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 11 personer och har ett genomsnittsbetyg på 4.2 stjärnor baserat på 6 recensioner. Har du en fråga om Cotech EMT448 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/5

UNITED KINGDOM • CUSTOMER SERVICE

tel 020 8247 9300 customerservice@clasohlson.co.uk www.clasohlson.co.uk 10 – 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZe-mail internet postal

Ver. 20180924

Engine Block Heater Timer with

Temperature Sensor

Art.no 36-6047 Model EMT448

Please read theentire instruction manual before using theproduct and then

save it for future reference. We reserve theright for any errors in text or images

and any necessary changes made to technicaldata. In theevent of technical

problems or other queries, please contact our Customer Services.

Safety

• Never try to dismantle, repair or modify theproduct in anyway.

• Make sure that theelectrical socket that theproduct is plugged into is

easily accessible in case it and theconnected product need to be quickly

disconnected from themains electricity.

• Do not connect products of this type to each other.

• Do not cover theproduct.

Buttons and functions

Operating instructions

Note: Thetimer has abuilt-in battery which is charged when thetimer is

plugged into awall socket (charging time is 2 hours). Itis therefore possible to

make settings (if thebattery is charged) even when thetimer is not plugged into

thewall socket. Thedisplay backlight cannot be lit when thetimer is unplugged

from thewall socket.

Setting the clock

1. Hold in [ OK ] until thehoursﬂash.

2. Press or hold in [ +1 ] or [ −1 ] to set thehours.

3. Press [ OK ] – theminutes display willﬂash.

4. Press or hold in [ +1 ] or [ −1 ] to set theminutes.

5. Press [ OK ] to conﬁrm and exit theclock setmode.

Setting the departure time

1. Press [ SET ]. Thehours will then begin toﬂash.

2. Press or hold in [ +1 ] or [ −1 ] to set thehours.

3. Press [ OK ] – theminutes display willﬂash.

4. Press or hold in [ +1 ] or [ −1 ] to set theminutes.

5. Press [ OK ] to conﬁrm and exit thesettingsmode.

Display backlight

Note: Thedisplay backlight can only be lit when thetimer is plugged into

awallsocket.

• Thebacklight will come on for 10 seconds whenever any of thebuttons

ispressed.

• Hold in [ SET ] for 3 seconds to switch thebacklight to “always on”mode.

• Hold in [ SET ] again to switch off thebacklight and set it to “on for

10seconds when button pushed”mode. Afteryou have held in Note:

thebutton for 3 seconds to change thebacklight from “always on” mode,

thebacklight will shine for 10 seconds before goingout.

Preset programmes

If you have for

example set your

departure time to ...

and thetemperature

where thetimer is

located is ...

thetimer will switch

theheater on at

07:00 5 °C ± 2 °C 30min before departure

07:00 0 °C ± 2 °C 60min before departure

07:00 −5 °C ± 2 °C 90min before departure

07:00 −10 °C ± 2 °C 120min before departure

07:00 −15 °C ± 2 °C or lower 180min before departure

• Thetimer will not switch theheater on if

thetemperature where thetimer is located is above

5 °C. Ifthetemperature rises to above 7 °C when

theheater is on, thetimer will switch theheateroff.

• Theheater will stay on 30 minutes past theset

departuretime. Itis −10 °C and thetimer Example:

switches theheater on 120 min before theset

departure time (see above). During these two hours,

thetemperature drops to −15 °C, thetimer does not

react to thechange in temperature but operates in

accordance with theinitial temperature detection of −10 °C.

• It takes about 45 minutes for thetimer to adapt to

anew temperature such as when it is taken out into

thecold from awarm indoor environment.

• Always make sure to insert thetimer into thewall

socket so it is orientated as shown in thepicture.

1. Clock

2. Departuretime

3. [ SET ] departure time setting

4. [ OK ] clock setting, conﬁrm

5. Time elapsed since theheater was switched on

6. [ −1 ] Setting

7. [ RST ] Reset all settings (thedeparture time resets to adefault setting of 07:00)

8. [ +1 ] Setting

Note:

Time elapsed since theheater has been switched on only

shows when theheater is switchedon.

Care and maintenance

• Clean thetimer by wiping it with adrycloth.

• Thetimer should be unplugged from thewall socket if it is not to be used for

alongtime.

Troubleshooting guide

Thetimer

does

notwork.

• Check theclock and timer settings and adjust if necessary.

• Try plugging theengine/car heater directly into thewall

socket without thetimer, to see if everythingworks.

• Make sure that thecable between thetimer and thecar is

intact and properly plugged into both thetimer andcar.

• Check that thecar heater is switched on, that thecable is

intact and properly plugged into theoutlet in thepassenger

compartment.

• Try plugging thecar heater into another electrical outlet to

make sure that itworks.

• Is thewall socket that thetimer is plugged intolive?

Responsible disposal

This symbol indicates that this product should not be disposed of

with general householdwaste. Thisapplies throughout theentire EU.

Inorder to prevent any harm to theenvironment or health hazards

caused by incorrect waste disposal, theproduct must be handed in

for recycling so that thematerial can be disposed of in aresponsible

manner. Whenrecycling your product, take it to your local collection

facility or contact theplace of purchase. Theywill ensure that

theproduct is disposed of in anenvironmentally sound manner.

Specifications

Power supply 230V AC, 50/60Hz

Load capacity 3680W, 16A

Operating temperature −20 to 45 °C

IP rating IP44

Produktspecifikationer

Varumärke:	Cotech
Kategori:	Inte kategoriserad
Modell:	EMT448

Behöver du hjälp?

Om du behöver hjälp med Cotech EMT448 ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

Inte kategoriserad Cotech Manualer

Cotech HT7715 Bruksanvisning

18 September 2024

Cotech J5218D Bruksanvisning

16 September 2024

Cotech 50053 Bruksanvisning

16 September 2024

Cotech 51097X23 Bruksanvisning

16 September 2024

Cotech HT8750-EUCLA Bruksanvisning

16 September 2024

Cotech 36-6286 Bruksanvisning

16 September 2024

Cotech K-CPL-LS4W-IR-S3 Bruksanvisning

16 September 2024

Cotech J1x-JF2-210/20 Bruksanvisning

15 September 2024

Cotech TD9511-3 Bruksanvisning

12 September 2024

Cotech S1J-AJ8-10 Bruksanvisning

1 September 2024

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer

Planet PWR-240-48 Bruksanvisning

9 April 2025

CaterChef 445001 Bruksanvisning

9 April 2025

Daikin EKWCTRDI1V3 Bruksanvisning

9 April 2025

Simplified MFG SP18CAT120 Bruksanvisning

9 April 2025

AudioQuest Pegasus Bruksanvisning

9 April 2025

Reolink P330 Bruksanvisning

9 April 2025

Reolink NVS16-8MB8 Bruksanvisning

9 April 2025

Drive Medical RTL12045 Bruksanvisning

9 April 2025

Kern MBC-A05 Bruksanvisning

9 April 2025

Daikin EKEXVA250 Bruksanvisning

9 April 2025