Craftsman CMXZRAZF333 Bruksanvisning

Craftsman Radio CMXZRAZF333

Läs gratis den bruksanvisning för Craftsman CMXZRAZF333 (2 sidor) i kategorin Radio. Guiden har ansetts hjälpsam av 12 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 6.5 recensioner. Har du en fråga om Craftsman CMXZRAZF333 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
Battery Low
When battery power is low, the final bar in the Battery Low
icon will blink and an audible tone will sound twice before the
radio shuts off. Your batteries should be replaced or recharged,
if using rechargeable batteries.
Auto Battery Save
If there are no transmissions within 10 seconds, the radio will
automatically switch to mode and the Power Save Power
radio’s ability to receive incoming transmissions.
Communicating with Another Person
1. Press and hold the button.Talk
2. With the microphone about two inches (5 cm) from your
mouth, speak in a normal voice.
3. Release the button when you are finished talking and Talk
listen for a response.
You cannot receive incoming calls while pressing the Talk
button.
To Select a Channel
With the radio , select any of the 22 channels by pressing on
the or button.Channel Up Channel Down
To temporarily turn off auto squelch
Press the button for Less than five seconds.Light/Max Range
To turn maximum range extender on
– Press and hold the Light/Max Range button for at least five
seconds until you hear two beeps which indicates the
maximum range extender is on.
To turn maximum range extender off
– Press and release the button or change Light/Max Range
channels.
Lock Function
The Lock function locks the and Channel Up, Channel Down
Mode/Power buttons to prevent accidental operation.
To turn the lock on or off
– Press and hold the button for two seconds. Lock
A double beep sound is used to conform your lock on or off
request. When in mode, the icon will be displayed.Lock Lock
Range
Your range will vary depending on terrain and conditions.
In flat, open country your radio will operate at maximum range.
Buildings and foliage in the path of the signal can reduce the
range of the radio.
Dense foliage and hilly terrain will further reduce the range of
the radio.
On FRS Channels 8 through 14, your radio automatically
switches to low power, which will limit the range the radio can
communicate.
Turning on Your Radio
Press and hold the button until you hear a Mode/Power
series of audible tones indicating the radio is on. Your radio is
now in mode, ready to receive transmissions. The Standby
radio is always in mode except when the , Standby Talk Call
or buttons are pressed.Mode/Power
Battery Status Indicator
The battery charge status is shown on the display. Four bars
indicates fully charged.
2
1
3
7
11
8
4
5
1 2
1 3
1 4
1 5
1 0
6
9
Introduction
Introduction
Product Features
Operation
Using Your Radio
1
2
3
4
5
6
1 1
1 2
1 3
1 0
8
7
9
CMXZRAZF333
A-1 A-2 A-3
1
2 3 4 5 6
Mode/Power
Mode/Power
Listening
Reduced Range
Reduced Range
Remember, you can achieve maximum
range by using maximum range extender.
See page 4 for details.
Operation
Mode Functions
TWO-WAY RADIO MODEL
User guide
Printed in China
Part No. KEM-ML42300-01
English
Making Life Easier and Safer
Staying in touch with your family and friends is convenient and easy when
using your radio. Some of the many uses you will discover include
Communicating with others while hiking, biking, and working; keeping track of family and
friends at a crowded public event; checking with travel
companions in another car; talking with neighbors; arranging
meeting spots with others while shopping at the mall.
Secure your radio while on the go.
Carrying your radio with you is easy when using the belt clip or
optional wrist strap.
The belt clip easily attaches to your belt, purse, or backpack.
Belt Clip
1. Antenna
2. External Speaker/ Microphone/Charge Jack
3. ButtonMode/Power
4. ButtonWeather/Lock
5. Buttons Channel Up/Down
6. Backlit LCD Display
7. Speaker/Microphone
8. ButtonsVolume Up/Down
9. ButtonLight/Max Range
10. ButtonTalk
11. ButtonCall
12. Wrist Strap Connection
13. Belt Clip
14. Battery Compartment
15. Battery Door Latch
Backlit LCD Display
Features
22 Channels
10 Channel NOAA All
Hazards Radio
Weather Alert
121 Privacy Codes
(38 CTCSS codes/ 83
DCS codes)
Hands-Free
Operation (VOX)
Scan
Channels, privacy
codes
Backlit LCD Display
Call Alert
Five selectable tones
Button Lock
Speaker/
Microphone/
Charge Jack
Roger Beep
Selectable On/Off
Battery/Power
Saver
Keystroke Tones
Battery Level
Indicator
Auto Squelch
Maximum Range
Extender
Belt Clip
1. Battery Level Indicator
2. VOX Icon
3. Scan Icon
4. Roger Beep Icon
5. Lock Icon
6. Low Power Icon
7. DCS/CTCSS Icons
8. Weather Icon
9. Weather Alert Icon
10. DCS/CTCSS Privacy Code Numbers
11. Power Saver Icon
12. Channel Numbers
13. Receive/Transmit Icon
Maximum range may vary and is based on unobstructed line-of-sight
communication under ideal conditions.
Caring for Your Radio
Your radio will give you years of trouble-free service if cared for properly. Handle the
radio gently. Keep the radio away from dust. Never put the radio in water or in a damp
place. Avoid exposure to extreme temperatures.
Installing Batteries
To install or replace batteries
1. Remove belt clip by releasing belt clip latch and sliding clip
up.
2. Pull up on the battery door latch to remove the battery
compartment cover.
3. Insert the supplied three AA rechargeable batteries or
non-rechargeable alkaline batteries. Position batteries
according to polarity markings.
4. Replace battery compartment cover and belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio
1. Check to see that the batteries have been inserted properly.
2. Insert the cable into the charge jack located at the top of the
radio.
3. Plug the cable into USB-compatible power port.
Use only the supplied rechargeable batteries and charger for recharging your radio.
Craftsman recommends your radio is turned off while being charged. Non-rechargeable
alkaline batteries can also be used in your radio.
Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Radio Charger Jack
Quick Start
1. Press and hold the button to turn on your radio.Mode/Power
2. Press the or button to select a Channel Up Channel Down
channel.
3. Press and hold the button while speaking into the Talk
microphone.
4. When finished talking, release the button and listen for a Talk
response.
Both radios must be tuned to the same
channel/privacy code to communicate.
Battery Charge
Status
Battery Low
Battery Save Mode
Talk Button
Two Inches (5 cm)
from Mouth
Channel Button
Channel Number
The radio will display flashing battery icon while
charging if the radio is on.
Both radios must be tuned to the same
channel to communicate.
Both radios must be tuned to the same channel
to communicate.
See for frequency allocations chart.page 13
Volume Button
Volume Level
Call Button
Light/MaxRange
Light/Max Range
Lock Button
Lock Icon
Maximum Range
Listening for a Response
Release the button to receive incoming transmissions. Your Talk
radio is always in mode while the or buttons Standby Talk Call
are not pressed.
To Adjust Volume
Press the or button. Volume Up Volume Down
A double beep sound is used to indicate the minimum and
maximum volume levels (1 through 8).
Call Button
Press and release the button. The other person will hear a Call
three second call tone. This tone is used only to establish voice
communications.
To Illuminate Display
Press and release the button to illuminate Light/Max Range
the display.
Auto Squelch/Maximum Range
Your radio will automatically shut off weak transmissions and unwanted noise due to
terrain, conditions or if you’ve reached your limit.Maximum Range
You can temporarily turn auto squelch or turn maximum range extender, allowing off on
all signals to be received and extending the maximum range of your radio.
See page 11 on how to select between five
call tone settings.
Mode Functions (continued on back side)
Scrolling Through the Mode Function
By scrolling through the function, you will be able to select or turn on Mode
preferred features of your radio. When scrolling through the function, your Mode
radio features will be displayed in the same predetermined order:
Set CTCSS Privacy Codes
Set DCS Privacy Codes
Set Vox On/Off
Set Vox Sensitivity
Set Channel Scan
Set CTCSS Privacy Code Scan
Set DCS Privacy Code Scan
Set Call Tones
Set Roger Beep On/Off
Privacy Codes
Your radio incorporates two advanced coded squelch systems that can help to
reduce interference from other users on any given channel. CTCSS (Continuous Tone
Coded Squelch System) provides 38 privacy codes and DCS (Digitally Coded
Squelch) provides 83 privacy codes. This provides a total of 121 . Privacy Codes
Either system can be used on all channels, but both systems cannot be used on the
same channel at the same time.
To successfully communicate using a privacy code, both the sending
and receiving radios must be tuned to the samechannel and to the
same privacy code system (CTCSS or DCS)and privacy code number.
Each channel will remember thelast privacy code system and number
you select.
The privacy code 00 is not a privacy code, but allows allsignals
to be heard on a channel that is set to 00 on boththe CTCSS and
DCS systems.
MODEL CMXZRAZF333:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference, and 2) this device must accept
any interference received,including interference that may cause undesired operation.
FCC Warnings: Replacement or substitution of transistors, regular diodes or other parts of a
unique nature, with parts other than those recommended by Craftsman may cause a
violation of the technical regulations of part 95 of the FCC rules, or violation of type
acceptance requirements of part 2 of the rules.
WARNING Important Safety Instructions for Battery
Read All Instructions
• Do not incinerate the battery even if it is severely damaged or is completely worn out. The battery pack
can explode in a fire.
• A small leakage of liquid from the battery cells may occur under extreme usage or temperature
conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on
your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If battery liquid gets into your eyes, flush them with clean water for a minimum of 10 minutes and seek
immediate medical attention. (Medical note: The liquid is 25-35% solution of potassium hydroxide.)
Recycle Battery
This product uses Nickel Metal Hydride batteries.
Local, state or federal laws may prohibit disposal of batteries in ordinary trash. Consult your local waste
authority for information regarding available recycling and/or disposal options.
1. Only accessories included in this package or specified by the manufacturer should be used with the
radio. The 5V micro-USB charging input is compatible with most high quality micro-USB chargers that
fully conform to the USB standards.
2. Do not use cleaners or solvents to clean the exterior of the radio. Use only a damp or dry cloth.
3. Do not expose this product to splashing or dripping water.
4. Do not attempt to service the receiver yourself. Removing the cover will void the warranty. Changes
or modifications not expressly approved by Craftsman may void the user’s authority granted by the
FCC to operate this device and should not be made.
5. Do not plug the wall adaptor into the power outlet if the outlet is wet.
WARNING Important Safety Instructions
Before operating the radio, please read all safety and operating instructions.
Save all instructions in a safe place for future reference.


Produktspecifikationer

Varumärke: Craftsman
Kategori: Radio
Modell: CMXZRAZF333

Behöver du hjälp?

Om du behöver hjälp med Craftsman CMXZRAZF333 ställ en fråga nedan och andra användare kommer att svara dig