Cres Cor EB-120 Bruksanvisning


Läs gratis den bruksanvisning för Cres Cor EB-120 (4 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 1.5 recensioner. Har du en fråga om Cres Cor EB-120 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/4
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
5925 Heisley Road Mentor, OH 44060-1833
Insulated
Banquet Cabinet
FL-2370
Rev. 1 (10/14) Page 1 of 4
Call Toll-free: 877-CRES COR (273-7267) Fax: 800-822-0393 www.crescor.com
ELECTRICAL SPECIFICATIONS:
EB-64
EB-96
EB-120
EB-150A
EB-150-XX
120 1500 12.5 60 1 5-15P
208 1500 7.3 60 1 6-15P
240 1500 6.3 60 1 6-15-P
Models are designed for AC Service.
Model Nos. may include sufxes: L, U, US, W, ST, Z and S.
HOW TO INSTALL UNIT:
1. Remove all packing material from inside the
cabinet and clean cabinet thoroughly.
2. Install all channels and shelves before the unit is
put into operation.
3. Plug the power cord into the proper wall outlet.
4. For W Humidity Models: Add water to pan in
hot unit.
HOW TO START UNIT:
1. Turn the switch . The yellow light POWER ON
will turn on.
2. Turn the thermostat to no. 10.
3. Preheat (assuming a cold cabinet of 75°F/2C):
To 150°F/65°C takes about 30 mins.
To 175°F/79°C takes about 45 mins.
To 190°F/88°C takes about 1 hour.
4. Put food into the cabinet.
5. Turn the thermostat to the required temperature.
NOTE: No. 8 is about 180°F/82°C
No. 7 is about 160°F/71°C
No. 6 is about 145°F/63°C
Proper food holding temperature is 140°F / 60°C or
higher.
TO TURN OFF UNIT:
Push the POWER switch to OFF.
The light will go out.yellow
Thermometer
Switch
w/Light
Thermostat
5925 Heisley Road Mentor, OH 44060-1833
Call Toll-free: 877-CRES COR (273-7267) Fax: 800-822-0393 www.crescor.com
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
Insulated
Banquet Cabinet
FL-2370
Rev. 1 (10/14) Page 2 of 4
Cleaning hints:
1. Wipe up spills as soon as possible.
2. Clean cabinet regularly to avoid heavy dirt build-up.
3. Make a test spot with cleaner.
4. Follow manufacturers directions on cleaner.
5. Do not mix cleaners.
6. Avoid drips and splashes.
7. Do not use Cres Clean on plastic parts or labels.
MAINTENANCE:
Hot Unit Removal Instructions
1. Unplug power cord from wall outlet and remove
cord from clip.
2. Lift up the bottom shelf: then lift up the hot unit
about 5 inches and pull out.
HOW TO CLEAN THE UNIT:
BEFORE Cleaning the Cabinet:
1. Allow cabinet to cool.
2. Remove hot unit from cabinet.
3. Do NOT use abrasives or harsh chemicals.
4. High pressure cleaning is recommended for
cabinet exterior.
WARNING
Soil Cleaner Method
CABINETS
(Stainless Steel)
Routine Cleaning Soap, ammonia, or
detergent* and water
1. Sponge on with cloth.
2. Rinse.
Stubborn spots
and stains
Mild abrasive made for
stainless steel
1. Apply with damp cloth.
2. Rub lightly.
Burnt-on foods or
grease.
Chemical oven cleaner 1. Apply generous coating.
2. Allow to stand for 10-15
minutes.
3. Rinse.
4. Repeat application if
necessary.
Hard water spots
and scale.
Vinegar 1. Swab or wipe with cloth.
2. Rinse dry.
*Mild detergents include soaps and non-abrasive cleaners.
OPERATING and MAINTENANCE INSTRUCTIONS
Models: EB Banquet Warming Cabinets
5925 Heisley Road Mentor, OH 44060-1833
Insulated
Banquet Cabinet
FL-2370
Rev. 1 (10/14) Page 3 of 4
Call Toll-free: 877-CRES COR (273-7267) Fax: 800-822-0393 www.crescor.com
TROUBLE-SHOOTING CHART:
FAILURE: POSSIBLE CAUSE:
1. Yellow light at switch does NOT light.
1a. Circuit breaker/fuse to wall outlet is blown
1b. Cord is unplugged from wall outlet.
1c. Switch is OFF.
2. Unit does not heat.
2a. Thermostat set too low or is OFF.
2b. Switch is OFF.
3. Unit gets too hot or wont shut off. 3a. Defective electrical parts.
UNPLUG UNIT FROM WALL OUTLET
4. Blower does not work or makes noise. 4a. Defective blower
5. Excess moisture in cabinet. 5. Slack out foods from oven or fryer for 5 minutes before
putting in hot cabinet.
If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400
REPLACEMENT PARTS:
DESCRIPTION 120 VOLT 208 VOLT 240 VOLT
Power Unit 1254-065 1254-066 1254-067
Blower Kit 0769-180-K 0769-182-K 0769-182-K
Heater Kit 0811-244 0811-245 0811-246
Thermostat Kit 0848-062-K 0848-062-K 0848-062-K
Thermometer Kit 5238-030-K 5238-030-K 5238-030-K
Power Cord 0810-029-02 0810-039-03 0810-039-03
Power Switch 0808-113-K 0808-113-01-K 0808-113-01-K
Terminal Block 0852-091 0852-091 0852-091
Water Pan 1017-129 1017-129 1017-129
CABINET MODEL NOS:
EB-64 EB-96 EB-120 EB-150A/EB-150XX
Door Latch 1006-143-K 1006-143-K 1006-143-K 1006-143-K
Door Strike 1006-151-K 1006-151-K 1006-151-K 1006-151-K
Door Hinge 0519-084 0519-084 0519-084 0519-084
Door Gasket Kit 0861-285-K 0861-285-K 0861-281-K 0861-282-K
Door Assembly, Complete 1221-615 1221-615 1221-607 1221-611
Wire Grid 1170-232 1170-228 1170-205 1137-231
Pull Handle 0911-087 0911-087 0911-119 0911-119
For Sterno ST Models:
5037-012 RH Can Holder
5037-013 LH Can Holder
0977-083 Sterno Cover


Produktspecifikationer

Varumärke: Cres Cor
Kategori: ej kategoriserat
Modell: EB-120

Behöver du hjälp?

Om du behöver hjälp med Cres Cor EB-120 ställ en fråga nedan och andra användare kommer att svara dig