Cres Cor IFW-63-10-PB Bruksanvisning

Cres Cor Lampa IFW-63-10-PB

Läs gratis den bruksanvisning för Cres Cor IFW-63-10-PB (2 sidor) i kategorin Lampa. Guiden har ansetts hjälpsam av 22 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 11.5 recensioner. Har du en fråga om Cres Cor IFW-63-10-PB eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/2
INSTALLATION INSTRUCTIONS
for PULL-DOWN INFRA RED MODELS IFW-63 SERIES
5925 Heisley Road Mentor, OH 44060-1833
Infra-red Lamps
IFW 63 Series
FL-2219
Rev. 2 (05/06) Page 1 of 2
Call Toll-free: 877-CRES COR (273-7267) Fax: 800-822-0393 www.crescor.com
ELECTRICAL SPECS:
120 250 2.0 60 1 5-15
240 275 1.1 60 1 6-15
Warmer should be installed by an experienced
electrician.
U.L. and CSA REQUIREMENTS:
A. Wires of warmers to be connected to 75°C wire.
B. Wires are to be installed in conduit.
C. Warmers are not to be installed any closer than 1 from
a wall.
D. Warmers must be 16 above a combustible at least
surface.
HOW TO INSTALL: (See gure at right)
NOTE: Outlet box (7) and screws (5) are to be furnished by
customer.
Pull canopy (2) down over coil cord.
Attach ground wire from ceiling to the GND hole in
the plate (4) with screw (6).
Wire the warmer leads to the outlet box (7) leads.
Attach plate (4) to the outlet box (7) with screws (5).
Lower or raise the coil cord to the height you want.
Adjust the tension of the coil cord in the slot as shown.
(a) To increase tension, turn slot clockwise.
(b) To decrease tension, turn slot counter clockwise.
7. Pull up canopy (2) and screw it to the plate (4) with two
machine screws (3).
8. Screw lamp into socket.
1.
2.
3.
4.
5.
6.
DO PULL NOT
DOWN ON CORD
BEYOND THE STOP.
Adjust Coil
Tension


Produktspecifikationer

Varumärke: Cres Cor
Kategori: Lampa
Modell: IFW-63-10-PB

Behöver du hjälp?

Om du behöver hjälp med Cres Cor IFW-63-10-PB ställ en fråga nedan och andra användare kommer att svara dig