Crestron MC3 Bruksanvisning

Läs gratis den bruksanvisning för Crestron MC3 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 30 personer. Har du en fråga om Crestron MC3 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

DOGUIDE

DO Install the Device

The MC3 is designed to be placed onto a at surface.

DO Make Connections

Make the necessary connections as called out in the diagrams

below. Connect power last.

When making connections to the MC3, note the following:

•Use Crestron® power supplies for Crestron equipment.

•The included cable(s) cannot be extended.

NOTE: Ensure the unit is properly grounded by connecting the

chassis ground lug to an earth ground (building steel).

NOTE: The MC3 can be powered via the Cresnet® connection

or with the (included) 24-Vdc power pack.

DO Congure the Control System

The MC3 can be congured using Crestron Toolbox™ software

and the built-in, web-based setup tool.

1. Use Crestron Toolbox to set the time zone. For details,

refer to the Crestron Toolbox help le.

2. Use the Internet Explorer® web browser to navigate to

http://xxx.xx.xx.xxx/setup, where xxx.xx.xx.xxx is the

IP address of the control system. The control system’s

welcome screen is displayed.

NOTE: The web-based setup tool is accessible only from

Internet Explorer.

NOTE: If a security warning is displayed, click Install to

continue.

DO Check the Box

QTYPRODUCTCOLORPART NUM.

1Connector, 3-PinGreen2003575

2Connector, 4-PinGreen2003576

1Antenna, 2.4 GHz, 1/4 Wave, Reverse Polarity, FemaleBlack2001016

1Power Pack, 24 Vdc, 2.5 A, 100-240 VacBlack2045873

1Power Cord, 5' 10" (1.78 m)2042043Black

1Cable, USB 2.0, A-B, 6’ (1.83 m)Black2014966

MC3

3-Series® Control System with Wireless Gateway

COM 1 - 2 Connections

PIN DESCRIPTION

2RXD - Receive Data

3TXD - Transmit Data

5SG - Signal Ground

7RTS - Request To Send

8CTS - Clear To Send

•Use with a standard DB9 straight

through cable.

•Pins 1, 4, 6, and 9 are not used but may

be connected.

AUDIO IN (L R):

From Audio Source

AUDIO OUT (L R):

To OSD Device or

Associated Amplifier

VIDEO OUT

(COMPOSITE):

To OSD Device

IR 1–5:

To IR Controlled

Devices

IR IN:

From IR

Device

VIDEO OUT (Y Pb Pr):

To OSD Device

COM 1–2:

To RS-232 Device

LAN:

10/100 Base-T

Ethernet to LAN

NET (24 Y Z G):

To Cresnet Network

RELAY 1–2:

To Controllable

Devices Ground

24 Vdc:

From Power

Supply

USB 1–2:

To USB HID Device

or USB Mass

Storage Device

INPUT:

From Control

Devices

Produktspecifikationer