Doepfer A-140-2v Bruksanvisning


Läs gratis den bruksanvisning för Doepfer A-140-2v (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 19 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 10 recensioner. Har du en fråga om Doepfer A-140-2v eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/4
A-140-2 Dual ADSR
Position and function of the jumpers and connectors Board A
The picture shows the factory setting of the jumpers.
To change the polarity of the second output (Output 2) the position of JP6/JP9 has to be changed.
To disconnect the unit from the gate signal on the bus JP11/JP10 has to be removed.
To change the direction of the time control voltage CVT (i.e. if an increasing CV increases or decreases the
time parameters) the position of JP7/JP4 has to be changed
If a parameter (A, D, R) should be removed from the CVT control the jumper in question has to be removed
Normally Systain is not affected by CVT (as it's not a time parameter) and the corresponding jumper is not
installed in the factory. If voltage control of Sustain is desired the corresponding jumper has to be installed
on the position "S" of JP8/JP5.
JP11/JP10:
Bus Gate
JP9/JP6: Polarity of Output 2
upper position = inverted
lower position = non-inverted
JP7/JP4: Time CV Polarity
upper position = inverted
lower position = non-inverted
JP8/JP5: Time CV assignment
when jumper installed the corresponding
parameter (A, D, S, R) is CV controlled
JP1:
Bus Connecto
r
ADSR #2 ADSR #1


Produktspecifikationer

Varumärke: Doepfer
Kategori: Inte kategoriserad
Modell: A-140-2v

Behöver du hjälp?

Om du behöver hjälp med Doepfer A-140-2v ställ en fråga nedan och andra användare kommer att svara dig