Dormakaba FSW Bruksanvisning
Läs gratis den bruksanvisning för Dormakaba FSW (7 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 18 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 9.5 recensioner. Har du en fråga om Dormakaba FSW eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/7
DORMA-Glas 800.52.055.6.32 Stand/Issue 02/03 Seite/Page 1/7
FSW Installation instructions
Track rail 75 x 72 mm
1. Ceiling substructure and installation of the track rail (Fig. 1):
The track rail must be bolted over its entire length (including the stacking track area) to a correctly
aligned ceiling substructure of steel. The steel substructure should be designed to accommodate the
total weight of all the panels. The substructure fixing point intervals for the track rail should be approx.
100 mm in the stacking area and approx. 300 mm along the remaining track sections. The maintenance
end piece (a) can be detached for panel installation, removal and servicing.
a
400
100100 100
Fig. 1
2. Fitting the hinged door rails to the glass panel (Fig. 2):
The door rail with either a panel hinge section or a frame hinge section consists of two profile sections
which are bolted together. (In order to avoid scratching, the cover profiles are clipped on only after the
system has been completely installed.) Slightly loosen the screws on the hinges and the door rails. Slide
the upper door rail onto the glass and clamp tightly. Glass insertion length: 25 mm. It is particularly
important to clamp the upper door rail correctly due to its bearing function. If the system is likely to be
subjected to vibration, silicone must be applied to the glass panels at the upper door rail for added
adhesion at the clamped connection.
Slide the lower door rail onto the glass and align it with the upper door rail. When aligning the door
rails, ensure that measurement A is the same for each folding panel.
A = total height of the system –353 mm.
After aligning the door rails, firmly tighten the M8 hex socket screws on both sides so that the rails
clamp the glass securely. (5 mm Allan key, tightening torque 20 Nm)
Fig. 2
Produktspecifikationer
| Varumärke: | Dormakaba |
| Kategori: | Inte kategoriserad |
| Modell: | FSW |
Behöver du hjälp?
Om du behöver hjälp med Dormakaba FSW ställ en fråga nedan och andra användare kommer att svara dig
Inte kategoriserad Dormakaba Manualer
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
Inte kategoriserad Manualer
- Soehnle
- BDI
- Thinkware
- Sennheiser
- Cabasse
- Ernitec
- Mikrotik
- Cambridge
- Elektrobock
- Haeger
- Mauser Sitzkultur
- Infosec
- Genexis
- Hovicon
- Enviroswim
Nyaste Inte kategoriserad Manualer
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025
9 April 2025