Ei Electronics Ei166RC Bruksanvisning

Ei Electronics Rökdetektor Ei166RC

Läs gratis den bruksanvisning för Ei Electronics Ei166RC (16 sidor) i kategorin Rökdetektor. Guiden har ansetts hjälpsam av 2 personer och har ett genomsnittsbetyg på 4.0 stjärnor baserat på 1.5 recensioner. Har du en fråga om Ei Electronics Ei166RC eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/16

IDEALLY INSTALL IN THE CENTRE OF CEILING

AT LEAST 300mm FROM LIGHT FITTINGS

LOCATE IONISATION ALARMS AWAY FROM

KITCHENS TO PREVENT NUISANCE ALARMS

ENSURE LIVE MAINS IS CORRECTLY

CONNECTED TO L TERMINALS ON ALL

INTERCONNECTED ALARMS - OTHERWISE

UNITS WILL BE DAMAGED

DO NOT FIT ACTUAL ALARM UNTIL ALL

BUILDING WORK IS COMPLETED TO AVOID

CONTAMINATION. AFTER CHECKING

OPERATION, COVER SMOKE ALARM WITH

DUST COVER UNTIL REQUIRED FOR USE

DISCONNECT THE ALARM BEFORE APPLYING

HIGH VOLTAGE INSULATION TESTS TO WIRING

DO NOT ATTEMPT TO OPEN THE ALARM AS

IT IS PERMANENTLY SEALED FOR SAFETY

DO NOT CONNECT ALTERNATIVE ENERGY

SOURCES e.g. WIND, SOLAR, UPS WITH

NON-SINUSOIDAL OUTPUTS

(see INSTALLATION section on page 10)

INTERCONNECT ALL ALARMS

230V~ SMOKE & HEAT ALARMS

INSTALLER INSTRUCTIONS

Ei141 - Ionisation Ei144 - Heat Ei146 - Optical

RECHARGEABLE LITHIUM CELL BACK-UP

Ei161RC - Ionisation Ei166RC - OpticalEi164RC - Heat

ALKALINE PRIMARY BATTERY BACK-UP

1.1 Installation Guide

2. ALARM REMOVAL

SLIDE ALARM OFF BASE

WITH THE SCREWDRIVER STILL INSERTED, PUSH THE LOWER

HALF OF THE ALARM AWAY FROM THE SCREWDRIVER, IN THE

DIRECTION OF THE ARROW ON THE COVER

HOLD THE LOWER HALF OF THE ALARM AND REMOVE FROM

THE BASE PLATE BY MOVING IT VERTICALLY DOWNWARDS,

WARD

THE FL

REMOVE ALARM

LOCATE REMOVAL SLOT

LOCATE THE ARROW ON THE FRONT FACE OF THE ALARM.

THE SLOT IS LOCATED DIRECTLY ABOVE THE ARROW.

INSERT SCREWDRIVER

INSERT A FLAT-BLADED SCREWDRIVER HORIZONTALLY

APPROX. 1cm INTO THE CENTRE OF THE REMOVAL SLOT

Produktspecifikationer

Varumärke:	Ei Electronics
Kategori:	Rökdetektor
Modell:	Ei166RC
Färg på produkten:	Zwart
Bredd:	129 mm
Djup:	10 mm
Höjd:	1075 mm
Förpackningens vikt:	3000 g
Förpackningens bredd:	80 mm
Djuppackning:	1140 mm
Förpackningshöjd:	80 mm
Antal per paket:	2 stuk(s)
Kompatibilitet:	APC Easy Rack
Rackkapacitet:	24U
Harmoniserad systemkod (HS):	85389099