Ei Electronics MCP401RC Bruksanvisning
Ei Electronics
Växla
MCP401RC
Läs gratis den bruksanvisning för Ei Electronics MCP401RC (2 sidor) i kategorin Växla. Guiden har ansetts hjälpsam av 8 personer och har ett genomsnittsbetyg på 4.2 stjärnor baserat på 4.5 recensioner. Har du en fråga om Ei Electronics MCP401RC eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
MCP401RC Manual Call Point
Disconnect the AC mains power supply from the circuit that is to
be used to power the smoke/heat alarms and the MCP401RC.
Install the Smoke/Heat/CO Alarms as per the Installer
Instructions supplied with the alarms.
Select a suitable location where the MCP401RC can be easily
accessed. The unit should not be exposed to dripping or splashing.
Route the wiring (Live, Neutral, Interconnect/Control and Earth)
to the MCP401RC siting location. A minimum 0.75mm
2cable
should be used.
With the 25mm screws provided, fix the mounting box to the wall.
Secure the wall plate to the mounting box using the 35mm
machine screws provided.
SURFACE MOUNTING BOX
SECURITY SCREW
1.5 x 10mm
SCREW (2)
3.5 x 35mm
WALL PLATE
FRONT COVER
OPERATING ELEMENT
SCREW (2)
3.5 x 25mm
Figure 1
Installation & Wiring
1
2
3
4
5
6Figure 2
To additional Ei Alarms
if required
(compatible alarms
listed above)
Figure 3
When the black spot on the front face of the MCP401RC is pressed, an alarm signal will be sent along the
interconnect line and all interconnected alarms will sound. The MCP401RC switch element can be reset using
the plastic key supplied.
PLEASE NOTE: The MCP401RC is designed for use with the following models of Smoke/Heat/CO Alarms
- Ei161RC, 164RC, 166RC, 141, 144, 146, 151TL, 154TL, 156TLH, 261ENRC, 261DENRC.
WARNING: This Manual Call Point should be installed by a qualified electrician in accordance with the
Requirements for Electrical Installations published by the Institute of Electrical Engineers (BS7671 current edition).
A maximum of 4 MCP401RC units can be installed on one system in addition to 12 interconnect alarms.
B16073-R0-MCP401RC-UC-ENG 19/4/07 9:17 AM Page 1
Produktspecifikationer
| Varumärke: | Ei Electronics |
| Kategori: | Växla |
| Modell: | MCP401RC |
Behöver du hjälp?
Om du behöver hjälp med Ei Electronics MCP401RC ställ en fråga nedan och andra användare kommer att svara dig
Växla Ei Electronics Manualer
16 Augusti 2024
28 Juli 2024
27 Juli 2024
26 Juli 2024
Växla Manualer
- Cisco
- Ebara
- Merlin Gerin
- ORNO
- STI
- Lindy
- Schneider
- Totolink
- Berker
- Tesla
- Clas Ohlson
- Suevia
- GEV
- IFM
- RGBlink
Nyaste Växla Manualer
9 April 2025
9 April 2025
7 April 2025
5 April 2025
5 April 2025
5 April 2025
5 April 2025
3 April 2025
3 April 2025
2 April 2025